The reason you can not set the ACTION bit with omset is because it is NOT SETTABLE.
However, one can still set it with the ever hazardous tool 'setpars'.
-----Original Message-----
From: Michael J Wing [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, July 31, 2001 8:43 AM
To: [EMAIL PROTECTED]
Subject: RE: Putting ECBs on/off line without using System Monitor
When I try to set the ACTION parameter with omset (only testing!) I get an errror code
of 15. This corresponds to "omopenlist already open". Is this perhaps because I'm
talking about an ECB that is used to communicate with an AB PLC on an AW51 integrator
rather than a more common FBM ECB? omget for this parameter returns a 0.
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Holger Dahl
Sent: Tuesday, July 31, 2001 2:37 AM
To: [EMAIL PROTECTED]
Subject: Putting ECBs on/off line without using System Monitor
David,
You can set the ACTION Parameter of the ECBs.
Setting this Parameter to "1" turns the ECB on, setting
it to "2" turns the ECB off.
Regards,
Holger Dahl
________________________________
erpicon software development GmbH
Neusser Str. 724-726
50737 Koeln
Tel: 0221-97460-70
Fax: 0221-97460-99
Email: [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
-----------------------------------------------------------------------
This list is neither sponsored nor endorsed by the Foxboro Company. All
postings from this list are the work of list subscribers and no warranty
is made or implied as to the accuracy of any information disseminated
through this medium. By subscribing to this list you agree to hold the
list sponsor(s) blameless for any and all mishaps which might occur due to
your application of information received from this mailing list.
To be removed from this list, send mail to
[EMAIL PROTECTED]
with "unsubscribe foxboro" in the Subject. Or, send any mail to
[EMAIL PROTECTED]
