On Tue, Dec 22, 2009 at 12:26:03PM -0700, Warren Block wrote: > On Tue, 22 Dec 2009, Anton Shterenlikht wrote: > > Warren, thank you, but this doesn't help. I've added: > > > > Section "Monitor" > > Identifier "Monitor0" > > HorizSync 30-50 > > VertRefresh 60 > > EndSection > > > > Section "Device" > > Identifier "Card0" > > Driver "mach64" > > BusID "PCI:0:2:0" > > EndSection > > Hmm. Some web searching says non-Intel platforms might need a different > reference clock: > > http://www.gentoo.org/doc/en/gentoo-sparc-faq.xml#doc_chap4_sect1
yes, now you told me I see it's actually in the logs: (--) MACH64(0): Reference clock 157.5/11 (14.318) MHz. (II) MACH64(0): If modes do not work on Ultra 5/10 or Blade 100/150, set option "reference_clock" to "28.636 MHz" or "29.5 MHz" by using either 28.636 or 29.5 I now get no "signal over range". In fact I just get a black screen. Not sure if this is worse or better... many thanks -- Anton Shterenlikht Room 2.6, Queen's Building Mech Eng Dept Bristol University University Walk, Bristol BS8 1TR, UK Tel: +44 (0)117 331 5944 Fax: +44 (0)117 929 4423 _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "freebsd-questions-unsubscr...@freebsd.org"