good morning,
I'd like to set up manual NAT on an high availability cluster.
( running NGX R61 HFA 01).
so I need to fill the sysctl.conf, add a static route and also add a
static arp entry.
as I'm running a splat high availability cluster, I also have to do the
same on every
member of the cluster.
the problem is that it will probably lead to duplicate arp or IP, as I
have to setup
a static arp entry on gateway A with MAC address from gatewayA_eth0 for
example,
and the same entry on gateway B with MAC address from gatewayB_eth0.
is there a way to tell the cluster to setup the arp only when the node
is active ?
in other words, is there a way to run a script when the node becomes
active,
and another when the node becomes standby ?
thanks
___________________________________________________________________________
Yahoo! Mail réinvente le mail ! Découvrez le nouveau Yahoo! Mail et son interface révolutionnaire.
http://fr.mail.yahoo.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================