It works!!!! Thanks!!! But, I've no sound... any idea? Now I did it manualy, should I add ivtv in my /etc/modules to load ivtv with this options in my /etc/modutils/ivtv?
-----Original Message----- From: [EMAIL PROTECTED] on behalf of Nick Rosier Sent: Sat 12/25/2004 5:42 PM To: [email protected] Subject: Re: [ivtv-devel] Problem channel tuning PVR-350 ivtv version 0.2.0 (rc3b) Bart, try using this; let the driver sort as much out as possible (don't specify card-type...) ==== alias char-major-81 videodev alias char-major-81-0 ivtv alias char-major-61 lirc_i2c options ivtv ivtv_std=2 tda9887=0 install ivtv /sbin/modprobe --ignore-install ivtv ; /sbin/modprobe ivtv-fb ==== Don't think you need to switch to PAL specificly; mine does it; check dmesg. N. On Sat, 25 Dec 2004 17:35:43 +0100, Bart Peeters <[EMAIL PROTECTED]> wrote: > > > I downloaded the ivtvdriver, build on my debian. > cat /dev/video0 > test.mpg > I tried a lot of frequencies with pltune, but I only receive differtent > mpg's with snow and noise... > I think that the card have a problem with tuning the frequencies. > Any idea? > > Dec 25 17:25:57 mythtv kernel: ivtv: ==================== START INIT IVTV > ==================== > Dec 25 17:25:57 mythtv kernel: ivtv: version 0.2.0 (rc3b) loading > Dec 25 17:25:57 mythtv kernel: ivtv: Linux version: 2.6.9-1-686 preempt 686 > gcc-3.3 > Dec 25 17:25:57 mythtv kernel: ivtv: In case of problems please include the > debug info > Dec 25 17:25:57 mythtv kernel: ivtv: between the START INIT IVTV and END > INIT IVTV lines when > Dec 25 17:25:57 mythtv kernel: ivtv: mailing the ivtv-devel mailinglist. > Dec 25 17:25:57 mythtv kernel: ivtv: Autodetected WinTV PVR 350 card > Dec 25 17:25:57 mythtv kernel: ivtv: Found an iTVC15 based chip > Dec 25 17:25:57 mythtv kernel: ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI > 18 (level, low) -> IRQ 177 > Dec 25 17:25:57 mythtv kernel: ivtv: Unreasonably low latency timer, > setting to 64 (was 32) > Dec 25 17:25:57 mythtv kernel: ivtv: XXX PCI device: 0x0661 vendor: 0x1039 > Dec 25 17:25:57 mythtv kernel: tveeprom: Hauppauge: model = 48139, rev = > K257, serial# = 7672506 > Dec 25 17:25:57 mythtv kernel: tveeprom: tuner = Philips FM1216 ME MK3 (idx > = 57, type = 38) > Dec 25 17:25:57 mythtv kernel: tveeprom: tuner fmt = PAL(D/K) (eeprom = > 0x74, v4l2 = 0x00400e17) > Dec 25 17:25:57 mythtv kernel: tveeprom: audio_processor = CS5331 (type = > 9) > Dec 25 17:25:57 mythtv kernel: ivtv: i2c attach [client=tveeprom[0],ok] > Dec 25 17:25:57 mythtv kernel: ivtv: Tuner Type 38, Tuner formats > 0x00400e17, Radio: yes, Model 0x00ad2557, Revision 0x00000001 > Dec 25 17:25:57 mythtv kernel: ivtv: PAL tuner detected > Dec 25 17:25:57 mythtv kernel: ivtv: SECAM tuner detected > Dec 25 17:25:57 mythtv kernel: ivtv: Radio detected > Dec 25 17:25:57 mythtv kernel: tuner: Ignoring new-style parameters in > presence of obsolete ones > Dec 25 17:25:57 mythtv kernel: tuner: chip found at addr 0xc2 i2c-bus ivtv > i2c driver #0 > Dec 25 17:25:57 mythtv kernel: ivtv: i2c attach [client=(tuner unset),ok] > Dec 25 17:25:57 mythtv kernel: saa7115: starting probe for adapter ivtv i2c > driver #0 (0x10005) > Dec 25 17:25:57 mythtv kernel: saa7115: detecting saa7115 client on address > 0x42 > Dec 25 17:25:57 mythtv kernel: saa7115: writing init values > Dec 25 17:25:57 mythtv kernel: ivtv: i2c attach [client=saa7115[0],ok] > Dec 25 17:25:57 mythtv kernel: saa7115: status: (1E) 0x40, (1F) 0xc0 > Dec 25 17:25:57 mythtv kernel: saa7127: video encoder driver version V 0.3 > loaded > Dec 25 17:25:57 mythtv kernel: saa7127: Selecting NTSC video Standard > Dec 25 17:25:57 mythtv kernel: saa7127: Selecting S-Video+Composite > Dec 25 17:25:57 mythtv kernel: saa7127: Turn WSS off > Dec 25 17:25:57 mythtv kernel: saa7127: Widescreen Mode 4:3 Full Format > Dec 25 17:25:57 mythtv kernel: saa7127: Selecting Normal Encoder Input > Dec 25 17:25:57 mythtv kernel: saa7127: Enable Video Output > Dec 25 17:25:57 mythtv kernel: ivtv: i2c attach [client=saa7127[0],ok] > Dec 25 17:25:57 mythtv kernel: msp34xx: ivtv version > Dec 25 17:25:57 mythtv kernel: msp34xx: init: chip=MSP3418W-B3, has NICAM > support, simple (D) mode, simpler (G) no-thread mode > Dec 25 17:25:57 mythtv kernel: msp34xx: $Id$ compiled on: Dec 22 2004 > 08:28:38 > Dec 25 17:25:57 mythtv kernel: ivtv: i2c attach [client=MSP3418W-B3,ok] > Dec 25 17:25:57 mythtv kernel: ivtv: Encoder revision: 0x02050032 > Dec 25 17:25:57 mythtv kernel: ivtv: Encoder Firmware is buggy, use version > 0x02040011 > Dec 25 17:25:57 mythtv kernel: ivtv: Decoder revision: 0x02020023 > Dec 25 17:25:57 mythtv kernel: ivtv: Configuring WinTV PVR 350 card with 9 > streams > Dec 25 17:25:57 mythtv kernel: ivtv: Create DMA stream 0 using 256 16384 > byte buffers 4194304 kbytes total > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 0 > minor 0 > Dec 25 17:25:57 mythtv kernel: ivtv: Create DMA stream 1 > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 1 > minor 32 > Dec 25 17:25:57 mythtv kernel: ivtv: Create stream 2 using 40 52224 byte > buffers 2097152 kbytes total > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 2 > minor 224 > Dec 25 17:25:57 mythtv kernel: ivtv: Create DMA stream 3 using 455 4608 > byte buffers 2097152 kbytes total > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 3 > minor 24 > Dec 25 17:25:57 mythtv kernel: ivtv: Create stream 4 > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 4 > minor 64 > Dec 25 17:25:57 mythtv kernel: ivtv: Create DMA stream 5 using 16 65536 > byte buffers 1048576 kbytes total > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 5 > minor 16 > Dec 25 17:25:57 mythtv kernel: ivtv: Create stream 6 using 1024 2048 byte > buffers 262144 kbytes total > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 6 > minor 228 > Dec 25 17:25:57 mythtv kernel: ivtv: Create stream 7 > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 7 > minor 232 > Dec 25 17:25:57 mythtv kernel: ivtv: Create DMA stream 8 > Dec 25 17:25:57 mythtv kernel: ivtv: Registered v4l2 device, streamtype 8 > minor 48 > Dec 25 17:25:57 mythtv kernel: ivtv: Setting Tuner 38 > Dec 25 17:25:57 mythtv kernel: tuner: type set to 38 (Philips PAL/SECAM > multi (FM1216ME MK3)) by ivtv i2c driver #0 > Dec 25 17:25:57 mythtv kernel: ivtv: Setting audio matrix to input 3, > output 1 > Dec 25 17:25:57 mythtv kernel: ivtv: Switching standard to PAL. > Dec 25 17:25:57 mythtv kernel: ivtv: ivtv_enc_thread: pid = 1197, itv = > 0xcc9c33c0 > Dec 25 17:25:57 mythtv kernel: ivtv: ivtv_dec_thread: pid = 1198, itv = > 0xcc9c33c0 > Dec 25 17:25:57 mythtv kernel: saa7115: decoder set norm PAL > Dec 25 17:25:57 mythtv kernel: saa7115: set audio: 0x01 > Dec 25 17:25:57 mythtv kernel: saa7127: Setting Encoder Video Standard > Dec 25 17:25:57 mythtv kernel: saa7127: Set PAL Video Mode > Dec 25 17:25:57 mythtv kernel: saa7127: Selecting PAL video Standard > Dec 25 17:25:57 mythtv kernel: ivtv: Initialized WinTV PVR 350, card #0 > Dec 25 17:25:57 mythtv kernel: ivtv: ==================== END INIT IVTV > ==================== > > > > and in my /etc/modutils/ivtv > > alias char-major-81 videodev > alias char-major-81-0 ivtv > options ivtv ivtv_debug=1 ivtv_std=2 cardtype=2 > ivtvctl -u 0xff > ivtvctl -p 4 > ivtvctl -v input=7,output=1 > > ------------------------------------------------------- SF email is sponsored by - The IT Product Guide Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now. http://productguide.itmanagersjournal.com/ _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
<<winmail.dat>>
