Hi, I'm having a few problems with my PVR 150. Basically, while using the 0.2.0 (rc3j) driver, I get nothing but a coloured fuzzy static on my tuner (but perfectly clear pictures on my SVideo and composite ports (in colour)).
Whilst using the 0.3.7 (a) driver, I get a clear picture on all three inputs - but the tuner and the SVideo are black and white. (It start off with lines of horizontal primary colours, but quickly turns into just greyscale.) Composite is fine. Which driver should I concentrate on? I pass no options, getting the driver to automagically detect my chip. The only file I have edited is: /etc/modprobe.d/aliases alias char-major-81-0 ivtv Thanks a lot for any help you can give. Various outputs of dmesg below: The version 0.3 driver (gives black and white): ivtv: version 0.3.7 (a) loading ivtv: Linux version: 2.6.10-5-686 preempt 686 gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Autodetected WinTV PVR 150 card ivtv: Found an iTVC16 based chip ivtv: Unreasonably low latency timer, setting to 64 (was 32) ivtv: XXX PCI device: 0x0651 vendor: 0x1039 ivtv: i2c attach [client=tveeprom[50],ok] ivtv: Tuner Type 38, Tuner formats 0x00400e17, Radio: yes, Model 0x008d1555, Rev ision 0x00000000 ivtv: PAL tuner detected ivtv: Radio detected tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv: i2c attach [client=(tuner unset),ok] cx25840: starting probe on adapter ivtv i2c driver #0 (0x10005) ivtv: i2c attach [client=cx25840[50],ok] ivtv: i2c attach [client=wm8775[50],ok] ivtv: i2c attach [client=tda9887,ok] ivtv: Encoder revision: 0x02040011 ivtv: Configuring WinTV PVR 150 card with 5 streams ivtv: Registered v4l2 device for encoder MPEG minor 0 ivtv: Create DMA encoder MPEG stream: 0 x 32768 buffers (0KB total) ivtv: Registered v4l2 device for encoder YUV minor 32 ivtv: Create DMA encoder YUV stream: 0 x 12960 buffers (0KB total) ivtv: Registered v4l2 device for encoder VBI minor 224 ivtv: Create DMA encoder VBI stream: 0 x 12740 buffers (0KB total) ivtv: Registered v4l2 device for encoder PCM audio minor 24 ivtv: Create DMA encoder PCM audio stream: 0 x 4608 buffers (0KB total) ivtv: Registered v4l2 device for encoder radio minor 64 ivtv: Create encoder radio stream ivtv: Setting Tuner 38 tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by ivtv i2c drive r #0 ivtv: ivtv_enc_thread: pid = 1686, itv = 0xcea3fac0 ivtv: ivtv_enc_vbi_thread: pid = 1687, itv = 0xcea3fac0 ivtv: Switching standard to PAL. ivtv: Initialized WinTV PVR 150, card #0 --- The 0.2 driver (gives static): ivtv: version 0.2.0 (rc3j) loading ivtv: Linux version: 2.6.10-5-686 preempt 686 gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Autodetected WinTV PVR 150 card ivtv: Found an iTVC16 based chip ivtv: Unreasonably low latency timer, setting to 64 (was 32) ivtv: XXX PCI device: 0x0651 vendor: 0x1039 ivtv: i2c attach [client=tveeprom,ok] ivtv: Tuner Type 4, Tuner formats 0x00400e17, Radio: yes, Model 0x008d1555, Revi sion 0x00000000 ivtv: PAL tuner detected ivtv: SECAM tuner detected ivtv: Radio detected tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv: i2c attach [client=(tuner unset),ok] ivtv: i2c attach [client=cx25840,ok] ivtv: i2c attach [client=wm8775,ok] ivtv: Encoder revision: 0x02040011 ivtv: Configuring WinTV PVR 150 card with 5 streams ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total ivtv: Registered v4l2 device, streamtype 0 minor 0 ivtv: Create DMA stream 1 ivtv: Registered v4l2 device, streamtype 1 minor 32 ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 2 minor 224 ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 3 minor 24 ivtv: Create stream 4 ivtv: Registered v4l2 device, streamtype 4 minor 64 ivtv: Setting Tuner 4 tuner: type set to 4 (NoTuner) by ivtv i2c driver #0 ivtv: Switching standard to PAL. ivtv: Initialized WinTV PVR 150, card #0 Thanks a lot, Martin ------------------------------------------------------- SF.Net email is Sponsored by the Better Software Conference & EXPO September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
