29.06.2010 01:03, KP Kirchdoerfer пишет: > Am Montag, 28. Juni 2010 23:02:37 schrieb Andrew: > >> 25.06.2010 23:34, KP Kirchdoerfer пишет: >> >>> Here's the output (no sata drivers loaded...) >>> >> Can you place here console output with kernel options VERBOSE=1 DEBUG=1 >> (in that case all errors/infos will be written to console)? >> > Here it is (below the one taht works with KMODULES=pata_amd): > > [ 0.022054] geode-mfgpt: 8 MFGPT timers available. > [ 0.023012] geode-mfgpt: Registered timer 0 > [ 0.024051] mfgpt-timer: Registering MFGPT timer 0 as a clock event, using > IRQ 7 > [ 0.026687] PCI: PCI BIOS revision 2.10 entry at 0xfcd03, last bus=0 > [ 0.027011] PCI: Using configuration type 1 for base access > [ 0.035536] bio: create slab<bio-0> at 0 > [ 0.036244] ACPI: Interpreter disabled. > [ 0.037550] vgaarb: loaded > [ 0.038712] PCI: Probing PCI hardware > [ 0.040111] pci 0000:00:09.0: PME# supported from D0 D1 D2 D3hot D3cold > [ 0.041014] pci 0000:00:09.0: PME# disabled > [ 0.042213] pci 0000:00:0a.0: PME# supported from D0 D1 D2 D3hot D3cold > [ 0.043017] pci 0000:00:0a.0: PME# disabled > [ 0.044184] pci 0000:00:0b.0: PME# supported from D0 D1 D2 D3hot D3cold > [ 0.045008] pci 0000:00:0b.0: PME# disabled > [ 0.047115] pci 0000:00:0f.4: PME# supported from D0 D3hot D3cold > [ 0.048013] pci 0000:00:0f.4: PME# disabled > [ 0.049329] pci 0000:00:0f.5: PME# supported from D0 D3hot D3cold > [ 0.050021] pci 0000:00:0f.5: PME# disabled > [ 0.055353] Switching to clocksource tsc > [ 0.056107] pnp: PnP ACPI: disabled > [ 0.060654] NET: Registered protocol family 2 > [ 0.066998] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) > [ 0.074419] TCP established hash table entries: 4096 (order: 3, 32768 > bytes) > [ 0.081711] TCP bind hash table entries: 4096 (order: 2, 16384 bytes) > [ 0.088325] TCP: Hash tables configured (established 4096 bind 4096) > [ 0.089171] TCP reno registered > [ 0.098131] NET: Registered protocol family 1 > [ 0.098857] Trying to unpack rootfs image as initramfs... > [ 0.306973] Freeing initrd memory: 788k freed > [ 0.307346] platform rtc_cmos: registered platform RTC device (no PNP > device found) > [ 0.321809] Scanning for low memory corruption every 60 seconds > [ 0.329450] HugeTLB registered 4 MB page size, pre-allocated 0 pages > [ 0.336993] msgmni has been set to 246 > [ 0.337327] alg: No test for stdrng (krng) > [ 0.345948] io scheduler noop registered > [ 0.346772] io scheduler cfq registered (default) > [ 0.574409] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled > [ 0.586264] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A > [ 0.600289] brd: module loaded > [ 0.608890] loop: module loaded > [ 0.616653] console [netcon0] enabled > [ 0.616827] netconsole: network logging started > [ 0.625787] PNP: No PS/2 controller found. Probing ports directly. > [ 0.632972] i8042.c: No controller found. > [ 0.633008] rtc_cmos rtc_cmos: rtc core: registered rtc_cmos as rtc0 > [ 0.644563] rtc0: alarms up to one day, 114 bytes nvram > [ 0.645372] cpuidle: using governor ladder > [ 0.654285] cpuidle: using governor menu > [ 0.655148] IPVS: Registered protocols () > [ 0.662564] IPVS: Connection hash table configured (size=4096, > memory=32Kbytes) > [ 0.670117] IPVS: ipvs loaded. > [ 0.670891] TCP cubic registered > [ 0.670891] NET: Registered protocol family 17 > [ 0.682322] rtc_cmos rtc_cmos: setting system clock to 2010-06-28 21:47:01 > UTC (1277761621) > [ 0.692269] Freeing unused kernel memory: 252k freed > LINUXRC: Bering - Initrd - 4.0.0 Rev 8 uClibc 0.9.30.3 > LINUXRC: Parsing kernel command line... > LINUXRC: Loading modules... > Next iteration: Mon Jun 28 21:47:02 UTC 2010 > Probing platform:rtc_cmos ... not found. > Probing platform:pcspkr ... not found. > Probing platform:serial8250 ... not found. > Probing pci:v00001022d00002080sv00001022sd00002080bc06sc00i00 ... not found. > Probing pci:v00001022d00002082sv00001022sd00002082bc10sc10i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v0000168Cd0000001Asv0000168Csd00002052bc02sc00i00 ... not found. > Probing pci:v00001022d00002090sv00001022sd00002090bc06sc01i00 ... not found. > Probing pci:v00001022d0000209Asv00001022sd0000209Abc01sc01i80 ...[ > 1.793449] SCSI subsystem initialized > found. > Probing pci:v00001022d00002094sv00001022sd00002094bc0Csc03i10 ...[ > 2.142108] usbcore: registered new interface driver usbs > [ 2.152137] usbcore: registered new interface driver hub > [ 2.159177] usbcore: registered new device driver usb > [ 2.179706] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver > [ 2.190230] ohci_hcd 0000:00:0f.4: OHCI Host Controller > [ 2.191006] ohci_hcd 0000:00:0f.4: new USB bus registered, assigned bus > number 1 > [ 2.203139] ohci_hcd 0000:00:0f.4: irq 15, io mem 0xefffe000 > [ 2.287598] usb usb1: configuration #1 chosen from 1 choice > [ 2.299071] hub 1-0:1.0: USB hub found > [ 2.299071] hub 1-0:1.0: 4 ports detected > found. > Probing pci:v00001022d00002095sv00001022sd00002095bc0Csc03i20 ...[ > 2.336427] ehci_hcd: USB 2.0 'Enhanced' Host Controllerr > [ 2.348764] Warning! ehci_hcd should always be loaded before uhci_hcd and > ohci_hcd, not after > [ 2.358308] ehci_hcd 0000:00:0f.5: EHCI Host Controller > [ 2.364374] ehci_hcd 0000:00:0f.5: new USB bus registered, assigned bus > number 2 > [ 2.392281] ehci_hcd 0000:00:0f.5: irq 15, io mem 0xefffd000 > [ 2.404940] ehci_hcd 0000:00:0f.5: USB 2.0 started, EHCI 1.00 > [ 2.411889] usb usb2: configuration #1 chosen from 1 choice > [ 2.418718] hub 2-0:1.0: USB hub found > [ 2.419428] hub 2-0:1.0: 4 ports detected > found. > Successfully probed 3 modules for 13 modaliases, currently loaded: > ehci_hcd 27299 0 - Live 0xc8995000 > ohci_hcd 17227 0 - Live 0xc897a000 > usbcore 101068 3 ehci_hcd,ohci_hcd, Live 0xc8947000 > pata_acpi 1968 0 - Live 0xc8914000 > libata 120640 1 pata_acpi, Live 0xc88de000 > scsi_mod 102693 1 libata, Live 0xc887f000 > vfat 7018 0 - Live 0xc8849000 > fat 37807 1 vfat, Live 0xc8831000 > isofs 19018 0 - Live 0xc8814000 > Next iteration: Mon Jun 28 21:47:04 UTC 2010 > Probing platform:rtc_cmos ... not found. > Probing platform:pcspkr ... not found. > Probing platform:serial8250 ... not found. > Probing pci:v00001022d00002080sv00001022sd00002080bc06sc00i00 ... not found. > Probing pci:v00001022d00002082sv00001022sd00002082bc10sc10i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v00001106d00003053sv00001106sd00000106bc02sc00i00 ... not found. > Probing pci:v0000168Cd0000001Asv0000168Csd00002052bc02sc00i00 ... not found. > Probing pci:v00001022d00002090sv00001022sd00002090bc06sc01i00 ... not found. > Probing pci:v00001022d0000209Asv00001022sd0000209Abc01sc01i80 ... found. > Probing pci:v00001022d00002094sv00001022sd00002094bc0Csc03i10 ... found. > Probing usb:v1D6Bp0001d0206dc09dsc00dp00ic09isc00ip00 ... found. > Probing pci:v00001022d00002095sv00001022sd00002095bc0Csc03i20 ... found. > Probing usb:v1D6Bp0002d0206dc09dsc00dp00ic09isc00ip00 ... found. > Successfully probed 5 modules for 15 modaliases, currently loaded: > ehci_hcd 27299 0 - Live 0xc8995000 > ohci_hcd 17227 0 - Live 0xc897a000 > usbcore 101068 3 ehci_hcd,ohci_hcd, Live 0xc8947000 > pata_acpi 1968 0 - Live 0xc8914000 > libata 120640 1 pata_acpi, Live 0xc88de000 > scsi_mod 102693 1 libata, Live 0xc887f000 > vfat 7018 0 - Live 0xc8849000 > fat 37807 1 vfat, Live 0xc8831000 > isofs 19018 0 - Live 0xc8814000 > LINUXRC: Root: /dev/ram0 > LINUXRC: Looking for leaf.cfg... > umount: can't umount /var/lib/lrpkg/mnt: Invalid argument > LINUXRC: Generating default dirs... > LINUXRC: Generating /tmp& /var/log partitions ... > LINUXRC: PKGPATH is empty or unset. Can not install packages. > LINUXRC: LRP= is empty or unset. Can not install packages. > LINUXRC: chown and chmod /dev... > /init: source: line 336: can't open '/var/lib/lrpkg/root.dev.own' > [ 4.812861] Kernel panic - not syncing: Attempted to kill init! > > Hm, it looks like pata_acpi is probed as IDE driver, and it isn't working correctly. Ok, I'll disable it in kernel.
------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ leaf-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/leaf-devel
