I've seen this mentioned before but I fail to understand the meaning. By layer three are you saying do not use VSWITCH? Al Schilla State of Minnesota
-----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] Behalf Of Alan Altmark Sent: Monday, May 09, 2005 3:21 PM To: LINUX-390@vm.marist.edu Subject: Re: Can't get vlan to work on suse sles9 64-bit On Monday, 05/09/2005 at 03:09 AST, David Kreuter <[EMAIL PROTECTED]> wrote: > Can't get vlan to work on suse sles9 64-bit. Loading the 8021q module works > fine, the config add command works fine, but whenever I try to configure the > device with an IP address, I go into a loop of some sort on the virtual > machine. Doesn't matter what IP address I use, whenever I issue ifconfig > eth1.11 ... loop occurs. Am I missing some service? It is my understanding that SLES9 layer 2 support is broken. There is a developerWorks patch that was picked up for SLES8, but hasn't been picked up for SLES9 (that is, hasn't been put in a service pack). I don't know which patch fixed the problem. I have heard from others that Novelle knows about the problem. If you have a support contract, ask them for the fix. Otherwise, try layer 3. Alan Altmark z/VM Development IBM Endicott ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
