Hello, I use since dvb-kernel under 2.4.? a script to run VDR and in case of VDR exit a small script:
#!/bin/bash export PATH=/sbin:/usr/sbin:/bin:/usr/bin:/usr/bin/X11:/usr/X11R6/bin:/usr/local/bin:/usr/games:/usr/local/games:. export DVDCSS_METHOD=key cd /usr/local/bin killall vdr-1.1 rmmod dvb_ttpci rmmod saa7146_vv rmmod video_buf rmmod saa7146 rmmod ttpci_eeprom modprobe video-buf modprobe saa7146 modprobe saa7146_vv modprobe dvb-ttpci hw_sections=0; /usr/bin/xawtv -c /dev/video0 -geometry 770x580-0-0 -xvport 51 & /usr/bin/perl -pi -e 's/\:16387$/\:0/' /video0/channels.conf /bin/nice -n -17 ./vdr-1.1 -Pbitstreamout -Pdvd -Pmp3 -Pmplayer -Posdpip -s /usr/local/bin/HALT This script worked very well till 2.6.0 on which I applied the 12 patches :-( (for example under 2.6.0t9-bk16 there wasn't any problem). Since 2.6.0+12 patches, it don't go further than rmmod dvb_ttpci and I have to kill the xterm in which it runs and then at the second execution, it reloads the driver perfectly and reload VDR... Same problem if I try to manualy rmmod dvb_ttpci: the shell don't come back... I have tried with firmware hotplug and with firmware compiled in. I am now under 2.6.1-rc1-mm2 and still same problem... I have two Hauppauge DVB-s rev 1.3, lsmod gives: Module Size Used by dvb_ttpci 312072 9 ttpci_eeprom 2560 1 dvb_ttpci saa7146_vv 45184 2 dvb_ttpci saa7146 15652 2 dvb_ttpci,saa7146_vv video_buf 17796 1 saa7146_vv lp 9280 0 parport_pc 37692 1 parport 36712 2 lp,parport_pc evdev 7808 0 hci_usb 9856 0 bluetooth 42980 1 hci_usb Any idea? Thank you very much, Grégoire ________________________________________________________________________ http://magma.epfl.ch/greg ICQ:16624071 mailto:[EMAIL PROTECTED] -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.