Andreas Share wrote: > > > > > > Be careful. The new code _works_ with BSRU6 (stv0299) and the old BSRV2 > > > module. Remember that DiSEqC is _always_ done by the av7110 on > > > full-featured cards. > > > > That is very weird.. So the new-ves1x93 must be in some mode that is > > interfering with the DISEQC being sent by the av7110... I can't think of > any > > other explanation. > > Hi, > > this could not be caused by the latest changes, because 1.1.0 doesnīt work > also. > > But between 1.0.1 and 1.1.0 was some init changed in ves1x93 related to the > polarisation. Maybe somone can test it with the old value... > > static > u8 init_1893_tab [] = { > 0x01, 0xA4, 0x35, 0x81, 0x2A, 0x0d, 0x55, 0xC4, > 0x09, 0x69, 0x00, 0x86, 0x4c, 0x28, 0x7F, 0x00, > 0x00, 0x81, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, > - 0x80, 0x00, 0x31, 0xb0, 0x14, 0x00, 0xDC, 0x00, > + 0x80, 0x00, 0x31, 0xb0, 0x14, 0x00, 0xDC, 0x20, > 0x81, 0x80, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, > 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, > 0x00, 0x55, 0x00, 0x00, 0x7f, 0x00 > }; > > This bit set the initial voltage to 0V (before 13V)... > > By the way....the hole before_after_tune/notifier stuff doesenīt work as > aspected...sometimes the driver run into the wrong funktion, because he > reported HAS_LOCK, but i was at the beginning of tunig, sometimes > av7110_before_after_tune() reported lock and set up the pids, but tuning > isenīt finished.
I tried this, but there was no change at all. Switching polarizations with DiSEqC still doesn't work reliably. Klaus -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.