[PATCH] [media] dvb-frontends/lnbh25: improve kernellog output

[Daniel Scheller]

From: Daniel Scheller <d.schel...@gmx.net>

Use dev_dbg() in conjunction with the %*ph format macro to print the vmon
status debug, thus hiding continuous hexdumping from default log levels.
Also, change the attach success log line from error to info severity.

Signed-off-by: Daniel Scheller <d.schel...@gmx.net>
---
 drivers/media/dvb-frontends/lnbh25.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/media/dvb-frontends/lnbh25.c 
b/drivers/media/dvb-frontends/lnbh25.c
index ef3021e964be..cb486e879fdd 100644
--- a/drivers/media/dvb-frontends/lnbh25.c
+++ b/drivers/media/dvb-frontends/lnbh25.c
@@ -76,8 +76,8 @@ static int lnbh25_read_vmon(struct lnbh25_priv *priv)
                        return ret;
                }
        }
-       print_hex_dump_bytes("lnbh25_read_vmon: ",
-               DUMP_PREFIX_OFFSET, status, sizeof(status));
+       dev_dbg(&priv->i2c->dev, "%s(): %*ph\n",
+               __func__, (int) sizeof(status), status);
        if ((status[0] & (LNBH25_STATUS_OFL | LNBH25_STATUS_VMON)) != 0) {
                dev_err(&priv->i2c->dev,
                        "%s(): voltage in failure state, status reg 0x%x\n",
@@ -178,7 +178,7 @@ struct dvb_frontend *lnbh25_attach(struct dvb_frontend *fe,
        fe->ops.release_sec = lnbh25_release;
        fe->ops.set_voltage = lnbh25_set_voltage;
 
-       dev_err(&i2c->dev, "%s(): attached at I2C addr 0x%02x\n",
+       dev_info(&i2c->dev, "%s(): attached at I2C addr 0x%02x\n",
                __func__, priv->i2c_address);
        return fe;
 }
-- 
2.13.0