This patch uses DT in order to parse addresses for dummy devices of adv7604.
If nothing is defined, it uses default addresses.
The main prupose is using two adv76xx on the same i2c bus.
Signed-off-by: Jean-Michel Hautbois <jean-michel.hautb...@vodalys.com>
---
.../devicetree/bindings/media/i2c/adv7604.txt | 7 ++-
drivers/media/i2c/adv7604.c | 56 ++++++++++++++--------
2 files changed, 42 insertions(+), 21 deletions(-)
diff --git a/Documentation/devicetree/bindings/media/i2c/adv7604.txt
b/Documentation/devicetree/bindings/media/i2c/adv7604.txt
index c27cede..221b75c 100644
--- a/Documentation/devicetree/bindings/media/i2c/adv7604.txt
+++ b/Documentation/devicetree/bindings/media/i2c/adv7604.txt
@@ -10,6 +10,7 @@ Required Properties:
- compatible: Must contain one of the following
- "adi,adv7611" for the ADV7611
+ - "adi,adv7604" for the ADV7604
- reg: I2C slave address
@@ -32,6 +33,8 @@ The digital output port node must contain at least one
endpoint.
Optional Properties:
- reset-gpios: Reference to the GPIO connected to the device's reset pin.
+ - reg-names : Names of registers to be reprogrammed.
+ Refer to source code for possible values.
Optional Endpoint Properties:
@@ -50,7 +53,9 @@ Example:
hdmi_receiver@4c {
compatible = "adi,adv7611";
- reg = <0x4c>;
+ /* edid page will be accessible @ 0x66 on i2c bus*/
+ reg = <0x4c 0x66>;
+ reg-names = "main", "edid";
reset-gpios = <&ioexp 0 GPIO_ACTIVE_LOW>;
hpd-gpios = <&ioexp 2 GPIO_ACTIVE_HIGH>;
diff --git a/drivers/media/i2c/adv7604.c b/drivers/media/i2c/adv7604.c
index d4fa213..4e660a2 100644
--- a/drivers/media/i2c/adv7604.c
+++ b/drivers/media/i2c/adv7604.c
@@ -326,6 +326,22 @@ static const struct adv7604_video_standards
adv7604_prim_mode_hdmi_gr[] = {
{ },
};
+static const char const *adv7604_secondary_names[] = {
+ "main", /* ADV7604_PAGE_IO */
+ "avlink", /* ADV7604_PAGE_AVLINK */
+ "cec", /* ADV7604_PAGE_CEC */
+ "infoframe", /* ADV7604_PAGE_INFOFRAME */
+ "esdp", /* ADV7604_PAGE_ESDP */
+ "dpp", /* ADV7604_PAGE_DPP */
+ "afe", /* ADV7604_PAGE_AFE */
+ "rep", /* ADV7604_PAGE_REP */
+ "edid", /* ADV7604_PAGE_EDID */
+ "hdmi", /* ADV7604_PAGE_HDMI */
+ "test", /* ADV7604_PAGE_TEST */
+ "cp", /* ADV7604_PAGE_CP */
+ "vdp" /* ADV7604_PAGE_VDP */
+};
+
/* ----------------------------------------------------------------------- */
static inline struct adv7604_state *to_state(struct v4l2_subdev *sd)
@@ -2528,13 +2544,27 @@ static void adv7604_unregister_clients(struct
adv7604_state *state)
}
static struct i2c_client *adv7604_dummy_client(struct v4l2_subdev *sd,
- u8 addr, u8 io_reg)
+ unsigned int i)
{
struct i2c_client *client = v4l2_get_subdevdata(sd);
+ struct adv7604_platform_data *pdata = client->dev.platform_data;
+ unsigned int io_reg = 0xf2 + i;
+ struct i2c_client *new_client;
+
+ /* Try to find it in DT */
+ new_client = i2c_new_secondary_device(client,
+ adv7604_secondary_names[i], io_read(sd, io_reg) >> 1);
- if (addr)
- io_write(sd, io_reg, addr << 1);
- return i2c_new_dummy(client->adapter, io_read(sd, io_reg) >> 1);
+ if (!new_client)
+ /* if not defined in DT, use default if available */
+ if (pdata && pdata->i2c_addresses[i])
+ new_client = i2c_new_dummy(client->adapter,
+ pdata->i2c_addresses[i]);
+
+ if (new_client)
+ io_write(sd, io_reg, new_client->addr << 1);
+
+ return new_client;
}
static const struct adv7604_reg_seq adv7604_recommended_settings_afe[] = {
@@ -2677,6 +2707,7 @@ MODULE_DEVICE_TABLE(i2c, adv7604_i2c_id);
static struct of_device_id adv7604_of_id[] __maybe_unused = {
{ .compatible = "adi,adv7611", .data = &adv7604_chip_info[ADV7611] },
+ { .compatible = "adi,adv7604", .data = &adv7604_chip_info[ADV7604] },
{ }
};
MODULE_DEVICE_TABLE(of, adv7604_of_id);
@@ -2717,20 +2748,6 @@ static int adv7604_parse_dt(struct adv7604_state *state)
/* Disable the interrupt for now as no DT-based board uses it. */
state->pdata.int1_config = ADV7604_INT1_CONFIG_DISABLED;
- /* Use the default I2C addresses. */
- state->pdata.i2c_addresses[ADV7604_PAGE_AVLINK] = 0x42;
- state->pdata.i2c_addresses[ADV7604_PAGE_CEC] = 0x40;
- state->pdata.i2c_addresses[ADV7604_PAGE_INFOFRAME] = 0x3e;
- state->pdata.i2c_addresses[ADV7604_PAGE_ESDP] = 0x38;
- state->pdata.i2c_addresses[ADV7604_PAGE_DPP] = 0x3c;
- state->pdata.i2c_addresses[ADV7604_PAGE_AFE] = 0x26;
- state->pdata.i2c_addresses[ADV7604_PAGE_REP] = 0x32;
- state->pdata.i2c_addresses[ADV7604_PAGE_EDID] = 0x36;
- state->pdata.i2c_addresses[ADV7604_PAGE_HDMI] = 0x34;
- state->pdata.i2c_addresses[ADV7604_PAGE_TEST] = 0x30;
- state->pdata.i2c_addresses[ADV7604_PAGE_CP] = 0x22;
- state->pdata.i2c_addresses[ADV7604_PAGE_VDP] = 0x24;
-
/* Hardcode the remaining platform data fields. */
state->pdata.disable_pwrdnb = 0;
state->pdata.disable_cable_det_rst = 0;
@@ -2891,8 +2908,7 @@ static int adv7604_probe(struct i2c_client *client,
continue;
state->i2c_clients[i] =
- adv7604_dummy_client(sd, state->pdata.i2c_addresses[i],
- 0xf2 + i);
+ adv7604_dummy_client(sd, i);
if (state->i2c_clients[i] == NULL) {
err = -ENOMEM;
v4l2_err(sd, "failed to create i2c client %u\n", i);
--
2.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
