On 11/11/2010 5:35 PM, Tony Lindgren wrote:
* Benoit Cousson<b-cous...@ti.com> [101019 15:14]:
--- a/arch/arm/mach-omap2/mux.h
+++ b/arch/arm/mach-omap2/mux.h
+
+/**
+ * struct mux_partition - contain partition related information
+ * @name: name of the current partition
+ * @flags: flags specific to this partition
+ * @phys: physical address
+ * @size: partition size
+ * @base: virtual address after ioremap
+ * @muxmodes: list of nodes that belong to a partition
+ * @node: list node for the partitions linked list
+ */
+struct omap_mux_partition {
+ const char *name;
+ u32 flags;
+ u32 phys;
+ u32 size;
+ void __iomem *base;
+ struct list_head muxmodes;
+ struct list_head node;
+};
With the omap_mux_parition..
/**
* struct omap_mux - data for omap mux register offset and it's value
* @reg_offset: mux register offset from the mux base
* @gpio: GPIO number
+ * @id: Partition identifier
* @muxnames: available signal modes for a ball
*/
struct omap_mux {
@@ -82,6 +114,7 @@ struct omap_mux {
char *muxnames[OMAP_MUX_NR_MODES];
#ifdef CONFIG_DEBUG_FS
char *balls[OMAP_MUX_NR_SIDES];
+ struct omap_mux_partition *partition;
#endif
#endif
};
@@ -89,6 +122,7 @@ struct omap_mux {
/**
* struct omap_ball - data for balls on omap package
* @reg_offset: mux register offset from the mux base
+ * @id: Partition identifier
* @balls: available balls on the package
*/
struct omap_ball {
@@ -100,6 +134,7 @@ struct omap_ball {
* struct omap_board_mux - data for initializing mux registers
* @reg_offset: mux register offset from the mux base
* @mux_value: desired mux value to set
+ * @id: Partition identifier
*/
struct omap_board_mux {
u16 reg_offset;
..I think the above changes are no longer needed.
Oops yep, I forgot to remove the @id in the kerneldoc.
I was about to send the next revision, maybe I should wait a little bit
more.
Thanks,
Benoit
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
