Use the new lane config in dsi_set_lane_config().
Signed-off-by: Tomi Valkeinen <tomi.valkei...@ti.com>
---
drivers/video/omap2/dss/dsi.c | 84 +++++++++++++++++++---------------------
1 files changed, 40 insertions(+), 44 deletions(-)
diff --git a/drivers/video/omap2/dss/dsi.c b/drivers/video/omap2/dss/dsi.c
index aea110c..ba8d6b3 100644
--- a/drivers/video/omap2/dss/dsi.c
+++ b/drivers/video/omap2/dss/dsi.c
@@ -2154,59 +2154,53 @@ static int dsi_parse_lane_config(struct omap_dss_device
*dssdev)
return 0;
}
-static void dsi_set_lane_config(struct omap_dss_device *dssdev)
+static int dsi_set_lane_config(struct omap_dss_device *dssdev)
{
struct platform_device *dsidev = dsi_get_dsidev_from_dssdev(dssdev);
+ struct dsi_data *dsi = dsi_get_dsidrv_data(dsidev);
+ static const u8 offsets[] = { 0, 4, 8, 12, 16 };
+ static const enum dsi_lane_function functions[] = {
+ DSI_LANE_CLK,
+ DSI_LANE_DATA1,
+ DSI_LANE_DATA2,
+ DSI_LANE_DATA3,
+ DSI_LANE_DATA4,
+ };
u32 r;
- int num_lanes_used = dsi_get_num_lanes_used(dssdev);
-
- int clk_lane = dssdev->phy.dsi.clk_lane;
- int data1_lane = dssdev->phy.dsi.data1_lane;
- int data2_lane = dssdev->phy.dsi.data2_lane;
- int clk_pol = dssdev->phy.dsi.clk_pol;
- int data1_pol = dssdev->phy.dsi.data1_pol;
- int data2_pol = dssdev->phy.dsi.data2_pol;
+ int i;
r = dsi_read_reg(dsidev, DSI_COMPLEXIO_CFG1);
- r = FLD_MOD(r, clk_lane, 2, 0);
- r = FLD_MOD(r, clk_pol, 3, 3);
- r = FLD_MOD(r, data1_lane, 6, 4);
- r = FLD_MOD(r, data1_pol, 7, 7);
- r = FLD_MOD(r, data2_lane, 10, 8);
- r = FLD_MOD(r, data2_pol, 11, 11);
- if (num_lanes_used > 3) {
- int data3_lane = dssdev->phy.dsi.data3_lane;
- int data3_pol = dssdev->phy.dsi.data3_pol;
-
- r = FLD_MOD(r, data3_lane, 14, 12);
- r = FLD_MOD(r, data3_pol, 15, 15);
+
+ for (i = 0; i < dsi->num_lanes_used; ++i) {
+ unsigned offset = offsets[i];
+ unsigned polarity, lane_number;
+ unsigned t;
+
+ for (t = 0; t < dsi->num_lanes_supported; ++t)
+ if (dsi->lanes[t].function == functions[i])
+ break;
+
+ if (t == dsi->num_lanes_supported)
+ return -EINVAL;
+
+ lane_number = t;
+ polarity = dsi->lanes[t].polarity;
+
+ r = FLD_MOD(r, lane_number + 1, offset + 2, offset);
+ r = FLD_MOD(r, polarity, offset + 3, offset + 3);
}
- if (num_lanes_used > 4) {
- int data4_lane = dssdev->phy.dsi.data4_lane;
- int data4_pol = dssdev->phy.dsi.data4_pol;
- r = FLD_MOD(r, data4_lane, 18, 16);
- r = FLD_MOD(r, data4_pol, 19, 19);
+ /* clear the unused lanes */
+ for (; i < dsi->num_lanes_supported; ++i) {
+ unsigned offset = offsets[i];
+
+ r = FLD_MOD(r, 0, offset + 2, offset);
+ r = FLD_MOD(r, 0, offset + 3, offset + 3);
}
- dsi_write_reg(dsidev, DSI_COMPLEXIO_CFG1, r);
- /* The configuration of the DSI complex I/O (number of data lanes,
- position, differential order) should not be changed while
- DSS.DSI_CLK_CRTRL[20] LP_CLK_ENABLE bit is set to 1. In order for
- the hardware to take into account a new configuration of the complex
- I/O (done in DSS.DSI_COMPLEXIO_CFG1 register), it is recommended to
- follow this sequence: First set the DSS.DSI_CTRL[0] IF_EN bit to 1,
- then reset the DSS.DSI_CTRL[0] IF_EN to 0, then set
- DSS.DSI_CLK_CTRL[20] LP_CLK_ENABLE to 1 and finally set again the
- DSS.DSI_CTRL[0] IF_EN bit to 1. If the sequence is not followed, the
- DSI complex I/O configuration is unknown. */
+ dsi_write_reg(dsidev, DSI_COMPLEXIO_CFG1, r);
- /*
- REG_FLD_MOD(dsidev, DSI_CTRL, 1, 0, 0);
- REG_FLD_MOD(dsidev, DSI_CTRL, 0, 0, 0);
- REG_FLD_MOD(dsidev, DSI_CLK_CTRL, 1, 20, 20);
- REG_FLD_MOD(dsidev, DSI_CTRL, 1, 0, 0);
- */
+ return 0;
}
static inline unsigned ns2ddr(struct platform_device *dsidev, unsigned ns)
@@ -2473,7 +2467,9 @@ static int dsi_cio_init(struct omap_dss_device *dssdev)
goto err_scp_clk_dom;
}
- dsi_set_lane_config(dssdev);
+ r = dsi_set_lane_config(dssdev);
+ if (r)
+ goto err_scp_clk_dom;
/* set TX STOP MODE timer to maximum for this operation */
l = dsi_read_reg(dsidev, DSI_TIMING1);
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
