On Tue, Mar 6, 2012 at 2:21 AM, Tony Lindgren <t...@atomide.com> wrote: > * Kevin Hilman <khil...@ti.com> [120305 11:28]: >> "Govindraj.R" <govindraj.r...@ti.com> writes: >> >> > From: "Govindraj.R" <govindraj.r...@ti.com> >> > >> > On beagle some of uart mux lines are used for other >> > purpose so init only uart3. >> >> OK, but you should also be clear that this patch is effectively >> disabling all UARTS (except UART3) by defatul, which I'm not sure all >> Beagle users will be happy about. >> >> > Uart2 rx line clashes with gpio_147 used for usb ehci >> > phy reset. Initializing uart2 pad_mux lines can break >> > ehci module on beagle xm. >> > (gpio_147 is available on uart2_rx in mode4 reference >> > mux34xx.c -> uart2_rx.gpio_147) >> >> As Koen mentioned, this conflict only exists on certain boards, so >> you should be clear that this is just an example. > > OK, thanks for the comments. Also it's a bit clear if > this really is safe to do on all beagles.
I have clarified the same in reply to "Kevin Hilman" and "Koen Kooi" in the same thread. > >> > Cc: Tony Lindgren <t...@atomide.com> >> > Cc: Kevin Hilman <khil...@ti.com> >> > Tested-by: Peter Ujfalusi <peter.ujfal...@ti.com> >> > Tested-by: Robert Nelson <robertcnel...@gmail.com> >> > Signed-off-by: Govindraj.R <govindraj.r...@ti.com> >> >> [...] >> >> > + >> > +static inline void board_serial_init(void) >> >> Should be __init >> >> [...] >> >> > +static inline void board_serial_init(void) >> >> here too. > > ..so dropping the patch for now until these are fixed > and we have some tested-bys for non-xm beagles too. > Okay fine, I have new version of the patch "[PATCH] omap3_beagle: init uart2 for beagle rev AX/BX only" This patch shouldn't have any impact and should work on beagles. -- Thanks, Govindraj.R -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
