Hi, I just updated the idrac firmware on an R710 :
#### [r...@gluster1 idrac]# sh IDRAC6_FRMW_LX_R271693.BIN Collecting inventory... .... Running validation... iDRAC6 The version of this Update Package is newer than the currently installed version. Software application name: iDRAC6 Package version: 1.50 Installed version: 1.03 Continue? Y/N:Y Executing update... WARNING: DO NOT STOP THIS PROCESS OR INSTALL OTHER DELL PRODUCTS WHILE UPDATE IS IN PROGRESS. THESE ACTIONS MAY CAUSE YOUR SYSTEM TO BECOME UNSTABLE! .................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................. Update Successful. #### But now I can't connect to the idrac. Did the settings on the idrac basically get blown away so that it doesn't remember what static IP I had set for it? How do I set the idrac ipv4 settings without going over to data center? Can I do it from Linux? I was looking at this : http://support.dell.com/support/edocs/software/smdrac3/idrac/idrac1.11/en/ug/html/chap02.htm#wp95392 but it doesn't look like it's possible? Thanks, Sabuj _______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge Please read the FAQ at http://lists.us.dell.com/faq
