On 01/24/2018 11:45 PM, James Smart wrote:
> Currently, write underruns (mismatch of amount transferred vs scsi
> status and its residual) detected by the adapter are not being
> flagged as an error. Its expected the target controls the data
> transfer and would appropriately set the RSP values.  Only read
> underruns are treated as errors.
> 
> Revise the SCSI error handling to treat write underruns as an
> error as well.
> 
> Signed-off-by: Dick Kennedy <dick.kenn...@broadcom.com>
> Signed-off-by: James Smart <james.sm...@broadcom.com>
> ---
>  drivers/scsi/lpfc/lpfc_scsi.c | 8 +++-----
>  1 file changed, 3 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/scsi/lpfc/lpfc_scsi.c b/drivers/scsi/lpfc/lpfc_scsi.c
> index dcc86936e6fc..10c2dc0cf1fa 100644
> --- a/drivers/scsi/lpfc/lpfc_scsi.c
> +++ b/drivers/scsi/lpfc/lpfc_scsi.c
> @@ -3772,20 +3772,18 @@ lpfc_handle_fcp_err(struct lpfc_vport *vport, struct 
> lpfc_scsi_buf *lpfc_cmd,
>               scsi_set_resid(cmnd, be32_to_cpu(fcprsp->rspResId));
>  
>               lpfc_printf_vlog(vport, KERN_INFO, LOG_FCP_UNDER,
> -                              "9025 FCP Read Underrun, expected %d, "
> +                              "9025 FCP Underrun, expected %d, "
>                                "residual %d Data: x%x x%x x%x\n",
>                                fcpDl,
>                                scsi_get_resid(cmnd), fcpi_parm, cmnd->cmnd[0],
>                                cmnd->underflow);
>  
>               /*
> -              * If there is an under run check if under run reported by
> +              * If there is an under run, check if under run reported by
>                * storage array is same as the under run reported by HBA.
>                * If this is not same, there is a dropped frame.
>                */
> -             if ((cmnd->sc_data_direction == DMA_FROM_DEVICE) &&
> -                     fcpi_parm &&
> -                     (scsi_get_resid(cmnd) != fcpi_parm)) {
> +             if (fcpi_parm && (scsi_get_resid(cmnd) != fcpi_parm)) {
>                       lpfc_printf_vlog(vport, KERN_WARNING,
>                                        LOG_FCP | LOG_FCP_ERROR,
>                                        "9026 FCP Read Check Error "
> 
I so hope you have this tested ...

Reviewed-by: Hannes Reinecke <h...@suse.com>

Cheers,

Hannes
-- 
Dr. Hannes Reinecke                Teamlead Storage & Networking
h...@suse.de                                   +49 911 74053 688
SUSE LINUX GmbH, Maxfeldstr. 5, 90409 Nürnberg
GF: F. Imendörffer, J. Smithard, J. Guild, D. Upmanyu, G. Norton
HRB 21284 (AG Nürnberg)

Reply via email to