[PATCH 04/15] qla2xxx: Use Correct index for Q-Pair array

[Himanshu Madhani]

From: Quinn Tran <qut...@marvell.com>

For target mode, the default number of Q-Pairs allowed
to use is 2. If the number of Q-Pair allocated is
lower than the default Q-Pairs, then lower value should
be the set as default.

Signed-off-by: Quinn Tran <qut...@marvell.com>
Signed-off-by: Himanshu Madhani <hmadh...@marvell.com>
---
 drivers/scsi/qla2xxx/qla_target.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/scsi/qla2xxx/qla_target.c 
b/drivers/scsi/qla2xxx/qla_target.c
index 1c1f63be6eed..d733e405c625 100644
--- a/drivers/scsi/qla2xxx/qla_target.c
+++ b/drivers/scsi/qla2xxx/qla_target.c
@@ -6671,6 +6671,8 @@ qlt_enable_vha(struct scsi_qla_host *vha)
        if (vha->qlini_mode == QLA2XXX_INI_MODE_ENABLED)
                return;
 
+       if (ha->tgt.num_act_qpairs > ha->max_qpairs)
+               ha->tgt.num_act_qpairs = ha->max_qpairs;
        spin_lock_irqsave(&ha->hardware_lock, flags);
        tgt->tgt_stopped = 0;
        qlt_set_mode(vha);
-- 
2.12.0