On Wed, Oct 24, 2012 at 3:10 PM, Rafael J. Wysocki <r...@sisk.pl> wrote: > On Wednesday 24 of October 2012 14:18:40 Bjorn Helgaas wrote: >> On Tue, Oct 23, 2012 at 11:14 AM, Ulrich Eckhardt <u...@uli-eckhardt.de> >> wrote: >> > Am 23.10.2012 01:40, schrieb Sarah Sharp: >> >> On Sun, Oct 21, 2012 at 06:03:24PM +0200, Ulrich Eckhardt wrote: >> > >> >>> I have tested it with Kernel 3.6.2. The USB3 port is the one built >> >>> in the Mainboard M4A87DT EVO. >> >> >> >> Did a previous kernel version work? >> > >> > Yes, I tried the Kernel shipped with OpenSUSE (3.4.11) several 3.5 and all >> > available 3.6 kernel versions. >> >> I assume you mean that every kernel you tried failed? If some >> kernel(s) did work, what is the newest working version and the oldest >> broken version? >> >> > I attach the complete dmesg logs and the lspci -vv output as requested by >> > Bjorn for the situations when the controller does not work after startup >> > (extension notworking), when the controller is working (extension OK), and >> > after stopping (extension stop). >> >> In the "notworking" logs, my guess is that the xHCI device is being >> powered off. The "notworking" lspci shows this: >> >> 00:0a.0 PCI bridge: Advanced Micro Devices [AMD] nee ATI RD790 PCI >> to PCI bridge (PCI express gpp port F) (prog-if 00 [Normal decode]) >> Bus: primary=00, secondary=04, subordinate=04, sec-latency=0 >> LnkCap: Port #247, Speed 5GT/s, Width x2, ASPM L0s L1, >> Latency L0 <64ns, L1 <1us >> LnkSta: Speed unknown, Width x1, TrErr- Train- >> SlotClk+ DLActive- BWMgmt+ ABWMgmt+ >> 04:00.0 USB controller: NEC Corporation uPD720200 USB 3.0 Host >> Controller (rev ff) (prog-if ff) >> !!! Unknown header type 7f >> Kernel driver in use: xhci_hcd >> >> The bridge's "DLActive-" means that the downstream link leading to the >> xHCI device is not active. The "rev ff", "prog-if ff", and "header >> type 7f" suggest that we read all 0xff's from the xHCI device, which >> is what we get if the device doesn't respond. >> >> The xHCI device must have been powered up and working originally, >> because we enumerated it and bound the xhci_hcd driver to it. I don't >> have any ideas about why it would be powered off. >> >> Rafael, Alan, is there any way we can disable power management or >> enable related debug messages? > > It can be disabled by writing "on" to the controller's > /sys/devices/.../power/control file.
Ulrich, if you boot in the working situation and write "on" to the control file as above, can you still reproduce the failure? > For debug, there are trace points in rpm_suspend() and rpm_resume(). I don't know how to use those. Is there a doc somewhere? -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
