Using the Sequoia (AMCC 440EPx) patches recently submitted to the list I
am unable to boot to fully boot a uImage built with these patches under
Uboot. It appears to hang in very early boot.
Here is the output:
=> tftp 400000 sequoia/uImage
ENET Speed is 100 Mbps - FULL duplex connection (EMAC0)
Using ppc_4xx_eth0 device
TFTP from server 9.53.41.24; our IP address is 9.53.41.38
Filename 'sequoia/uImage'.
Load address: 0x400000
Loading: #################################################################
#################################################################
#################################################################
#######################
done
Bytes transferred = 1112434 (10f972 hex)
=> bootm 400000
## Booting image at 00400000 ...
Image Name: Linux-2.6.23-rc2
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1112370 Bytes = 1.1 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev
