The following series implements basic board support for GE Fanuc's SBC610, a
6U single board computer, based on Freescale's MPC8641D.
This series provides basic functionality:
- The board can boot with a serial console.
- Ethernet works, though the phys are polled.
- The PCI bus is scanned and sata functions.
Signed-off-by: Martyn Welch <[EMAIL PROTECTED]>
---
Kumar & Scott: Thanks again for your comments.
I have:
- Removed all of the "device_type" entries I believe I can
- Moved the default config to new directory "arch/powerpc/configs/86xx/"
- "mac-address" changed to "local-mac-address"
- Removed un-needed #add/size and other defunct entries
- Use common interrupt routine.
Martyn
Martyn Welch (2):
powerpc: Default configuration for GE Fanuc SBC610
powerpc: Board support for GE Fanuc SBC610
arch/powerpc/boot/dts/gef_sbc610.dts | 268 +++++
arch/powerpc/configs/gef_sbc610_defconfig | 1654 +++++++++++++++++++++++++++++
arch/powerpc/platforms/86xx/Kconfig | 9
arch/powerpc/platforms/86xx/Makefile | 1
arch/powerpc/platforms/86xx/gef_sbc610.c | 187 +++
5 files changed, 2118 insertions(+), 1 deletions(-)
create mode 100644 arch/powerpc/boot/dts/gef_sbc610.dts
create mode 100644 arch/powerpc/configs/gef_sbc610_defconfig
create mode 100644 arch/powerpc/platforms/86xx/gef_sbc610.c
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev
