Benjamin Herrenschmidt wrote:
On Fri, 2010-01-29 at 18:04 -0600, Corey Minyard wrote:
From: Corey Minyard <cminy...@mvista.com>
The MPSC drivers that use DMA need to set coherent_dma_mask to allow
dma_alloc_xxx routines to work properly. Also, the mpsc serial driver
needed to set pi->port.dev to register properly. With these fixes,
the MPSC drivers seem to work again.
Signed-off-by: Corey Minyard <cminy...@mvista.com>
---
Is that enough ? Since 2.6.31 we also need the dma ops to be filled
properly and obviously that isn't going to happen for random platform
devices... Or are those initialized elsewhere by your platform code ? In
which case it might be a good place to also set the coherent mask...
That's done in ppc_dflt_bus_notify(), but that didn't seem an appropriate
place to do this. If it is, it's easy enough to add it there, but that
would
mean it would get set for all devices on any type of ppc system.
-corey
Maybe we should have a more generic way to set the "default" dma
information (including ops, masks etc...) for use by platform,
of_platform etc... devices.
Cheers,
Ben.
I'm not really sure about where to set the coherent_dma_mask, it seems
like a more general place would be better but I couldn't find it.
Without these, the console stops working after the switchover andantipode
the network driver fails to allocate buffers. With these, my board
boots up and works fine.
Index: linux-2.6.31/drivers/serial/mpsc.c
===================================================================
--- linux-2.6.31.orig/drivers/serial/mpsc.c
+++ linux-2.6.31/drivers/serial/mpsc.c
@@ -2071,6 +2071,9 @@ static int mpsc_drv_probe(struct platfor
if (!(rc = mpsc_drv_map_regs(pi, dev))) {
mpsc_drv_get_platform_data(pi, dev, dev->id);
+ dev->dev.coherent_dma_mask = DMA_BIT_MASK(32);
+ pi->port.dev = &dev->dev;
+
if (!(rc = mpsc_make_ready(pi))) {
spin_lock_init(&pi->tx_lock);
if (!(rc = uart_add_one_port(&mpsc_reg,
Index: linux-2.6.31/drivers/net/mv643xx_eth.c
===================================================================
--- linux-2.6.31.orig/drivers/net/mv643xx_eth.c
+++ linux-2.6.31/drivers/net/mv643xx_eth.c
@@ -2916,7 +2916,7 @@ static int mv643xx_eth_probe(struct plat
mp->shared = platform_get_drvdata(pd->shared);
mp->base = mp->shared->base + 0x0400 + (pd->port_number << 10);
mp->port_num = pd->port_number;
-
+ pdev->dev.coherent_dma_mask = DMA_BIT_MASK(32);
mp->dev = dev;
set_params(mp, pd);
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
