On Fri, Mar 9, 2012 at 12:09 AM, javadi ramesh <ramesh...@gmail.com> wrote: > Hi, > > I Ported Meego on Panda Board with Linux Kernel 3.2.7 Version.I Compiled > Kernel with Enabling driver nl80211 features. > > Meego Booted Successfully.Compiled and Ported WPA Supplicant for ARM target. > > After that I am able to findout wifi Network though my Panda Board. > > i am running the following Command. > > wpa_supplicant -B -Dnl80211 -c /etc/wpa_supplicant.conf -i wlan0 -dd > > Result: > > Initializing interface 'wlan0' conf '/etc/wpa_supplicant.conf' driver > 'nl80211' ctrl_interface 'N/A' bridge 'N/A' > Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf' > Reading configuration file '/etc/wpa_supplicant.conf' > cterface='/var/run/wpa_ > update_config=1 > netlite: linkmode=1, operstate=5 > nl80211: Register Action command failed: ret=-114 (Operation already in > progress) > nl80211: Register Action match - hexdump(len=1): 06 > nl80211: Failed to register Action frame processing - ignore for now > Own MAC address: de:ad:be:ef:0river_nl80211_set_key: ifindex=3 alg=0 > addr=0x7ff88 key_ > wpa_driver_nl80211_set_key: ifindset_tx=0 seq_len=0 key_a_driver_nl80 > ifindex=3 alg=0 addr=0x7ff88 key_idx=2 set_tx=0 seq_len=0 key_len=0 > wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=0x7ff88 key_idx=3 set_tx=0 > sen the driver > State: DISCONNECTED -> INACTIVE > WPS: UUID based on MAC address - 16): eb 6c 86 6b 88 24b d5 5c > EAE entering state DISCONNECTED > EAPOL: Supplicant port staorized > EAPOL: KEY_RX entering state NO_KEY_RECEIVE > EAPOL: SUPP_BE entering state INITIALItate DISABLED > EAPOL: Supplicant port status: Unauthorized > EAPOL: Supplicant port status: Unauthorized > Added interface wlan0 > Daemonize.. > > After that I am running wpa_cli command entering to the interactive mode. > > Here If i run Peer to Peer Commands,it is giving unknown commands. > > EXample: > > p2p_find > Unknown Command. > > > Can you Please help me on this Issue.My Panda board has TI wifi Chipset.
MeeGo doesn't support a 3.2.7 kernel, and that's probably where you are running into problems. In order to do what you want to do, you'll likely have to update much more parts of meego than just the kernel. Given the state of the project, that's probably not something you can expect much more help with. Perhaps the Community OBS folks have done some of this. Otherwise, the Mer project. Auke _______________________________________________ MeeGo-community mailing list MeeGo-community@meego.com http://lists.meego.com/listinfo/meego-community http://wiki.meego.com/Mailing_list_guidelines
