Hi there,
try to get the above things to work. According to this:
http://marc.info/?l=openbsd-misc&m=123634734730607&w=2
the dell 3g modem should workand basically it does. It's regognized, attaches
as a
usbdev
--- snip usbdevs ---
addr 1: EHCI root hub, AMD
addr 2: Dell Wireless 5530 HSPA Mobile Broadband Minicard Device, Dell
addr 1: OHCI root hub, AMD
--- snap usbdevs ---
can send PIN/Init get responses. But it delivers these errors:
ehci_idone: ex=0xd0fefb00 is done!
This also happens with a Huawei E169G 3G device on the external usb port.
Any mass device works flawlessly. I've tried it with different power
supplies, 9/12/16 volts, but there's no change. And it's not possible to
login to my provider via pppd/3G/ and the working chatscript for this
provider. I can still connect via cu(1) to the modem and issue commands.
Any ideas?
ThX
Andri
-- SNIP dmesg ---
OpenBSD 4.6 (GENERIC) #58: Thu Jul 9 21:24:42 MDT 2009
dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499
MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem = 268009472 (255MB)
avail mem = 250335232 (238MB)
RTC BIOS diagnostic error 80<clock_battery>
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 11/05/08, BIOS32 rev. 0 @ 0xfd088
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xe0000/0xa800
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address
00:0d:b9:1b:54:a8
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063,
model 0x0034
vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address
00:0d:b9:1b:54:a9
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063,
model 0x0034
ral0 at pci0 dev 12 function 0 "Ralink RT2560" rev 0x01: irq 9, address
00:0f:ea:84:5b:a2
ral0: MAC/BBP RT2560 (rev 0x04), RF RT2525
glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 0, 32-bit
3579545Hz timer, watchdog, gpio
gpio0 at glxpcib0: 32 pins
pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0
wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <TRANSCEND>
wd0: 1-sector PIO, LBA, 3823MB, 7831152 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version 1.0,
legacy support
ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
isa0 at glxpcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
biomask f1e7 netmask ffe7 ttymask ffff
mtrr: K6-family MTRR support (2 registers)
nvram: invalid checksum
umodem0 at uhub0 port 2 configuration 1 interface 1 "Dell Dell Wireless 5530
HSPA Mobile Broadband Minicard Device" rev 2.00/0.00 addr 2
umodem0: data interface 2, has CM over data, has break
umodem0: status change notification available
ucom0 at umodem0
umodem1 at uhub0 port 2 configuration 1 interface 3 "Dell Dell Wireless 5530
HSPA Mobile Broadband Minicard Device" rev 2.00/0.00 addr 2
umodem1: data interface 4, has CM over data, has break
umodem1: status change notification available
ucom1 at umodem1
umodem2 at uhub0 port 2 configuration 1 interface 9 "Dell Dell Wireless 5530
HSPA Mobile Broadband Minicard Device" rev 2.00/0.00 addr 2
umodem2: data interface 12, has CM over data, has break
umodem2: no data interface
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
clock: unknown CMOS layout
ehci_idone: ex=0xd0fefb00 is done!
ehci_idone: ex=0xd0fefc00 is done!
ehci_idone: ex=0xd0fefc00 is done!
ehci_idone: ex=0xd0fefe00 is done!
-- SNAP dmesg --
