Richard Gerrits wrote:
>
> >People, I discovered a flaw in the JoyNet specification.
> I discovered another one. In the section about connecting a MSX to a PC
> there is something like this:
>
> MSX PC
> 1 /FORWARD (IN)----------13 SEL (IN)
> 2 /BACK (IN)----------12 PE (IN)
> 3 /LEFT (IN)----------10 /ACK (IN)
> 6 /TRG1 (IN/OUT)----------2 D0 (OUT)
> 7 /TRG2 (IN/OUT)----------3 D1 (OUT)
> 8 OUTPUT (OUT)----------4 D3 (OUT)
> 9 GND-------------------------25 GND
>
> This should be:
> MSX PC
> 1---------2
> 2---------3
> 3---------4
> 6--------13
> 7--------12
> 8--------10
> 9--------25
It must be at my JoyNet page...
I made it based on data at DATAX page (the official page).
Now, checking the official page, made by Laurens Holst, I found:
JoyNet to PC cable
PC (DB25 /m) pin layout:
12 - RECV pin 1
13 - RECV pin 2
RECV (DIN5 180 /f) pin layout:
1 - PC pin 13
2 - PC pin 12
Which is correct ? Is the diagram (picture) right ?
Thank you.
Werner Kai
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
