On Fri, Apr 09, 2021 at 07:10:53PM +0530, Aswath Govindraju wrote: > From: Faiz Abbas <faiz_ab...@ti.com> > > Some transceivers need a configuration step (for example, pulling the > standby or enable lines) for them to start sending messages. The > transceiver can be implemented as a phy with the configuration done in the > phy driver. The bit rate limitation can the be obtained by the driver using > the phy node. > > Document the above implementation in the bosch mcan bindings > > Signed-off-by: Faiz Abbas <faiz_ab...@ti.com> > Signed-off-by: Aswath Govindraju <a-govindr...@ti.com> > --- > Documentation/devicetree/bindings/net/can/bosch,m_can.yaml | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml > b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml > index 798fa5fb7bb2..2c01899b1a3e 100644 > --- a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml > +++ b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml > @@ -109,6 +109,12 @@ properties: > can-transceiver: > $ref: can-transceiver.yaml# > > + phys: > + minItems: 1
maxItems: 1 > + > + phy-names: > + const: can_transceiver Kind of a pointless name. You don't really need a name if there's a single entry. > + > required: > - compatible > - reg > -- > 2.17.1 >
