Remove the old hack to program an initial EEPROM setting
into the DM9000 as we now have ethtool support for reading
and writing the EEPROM.
Signed-off-by: Ben Dooks <[EMAIL PROTECTED]>
Index: linux-2.6.24-quilt3/drivers/net/dm9000.c
===================================================================
--- linux-2.6.24-quilt3.orig/drivers/net/dm9000.c
+++ linux-2.6.24-quilt3/drivers/net/dm9000.c
@@ -191,10 +191,6 @@ static void dm9000_write_eeprom(board_in
static void dm9000_rx(struct net_device *);
static void dm9000_hash_table(struct net_device *);
-//#define DM9000_PROGRAM_EEPROM
-#ifdef DM9000_PROGRAM_EEPROM
-static void program_eeprom(board_info_t * db);
-#endif
/* DM9000 network board routine ---------------------------- */
static void
@@ -699,9 +695,6 @@ dm9000_probe(struct platform_device *pde
ndev->poll_controller = &dm9000_poll_controller;
#endif
-#ifdef DM9000_PROGRAM_EEPROM
- program_eeprom(db);
-#endif
db->msg_enable = NETIF_MSG_LINK;
db->mii.phy_id_mask = 0x1f;
db->mii.reg_num_mask = 0x1f;
@@ -1115,28 +1108,6 @@ dm9000_write_eeprom(board_info_t *db, in
mutex_unlock(&db->addr_lock);
}
-#ifdef DM9000_PROGRAM_EEPROM
-/*
- * Only for development:
- * Here we write static data to the eeprom in case
- * we don't have valid content on a new board
- */
-static void
-program_eeprom(board_info_t * db)
-{
- u16 eeprom[] = { 0x0c00, 0x007f, 0x1300, /* MAC Address */
- 0x0000, /* Autoload: accept nothing */
- 0x0a46, 0x9000, /* Vendor / Product ID */
- 0x0000, /* pin control */
- 0x0000,
- }; /* Wake-up mode control */
- int i;
- for (i = 0; i < 8; i++)
- write_srom_word(db, i, eeprom[i]);
-}
-#endif
-
-
/*
* Calculate the CRC valude of the Rx packet
* flag = 1 : return the reverse CRC (for the received packet CRC)
--
Ben ([EMAIL PROTECTED], http://www.fluff.org/)
'a smiley only costs 4 bytes'
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
