> Lots of good progress here! I tried to enable a few more commands for > your model. For instance, the "M" values seem to be min/max voltage, > so there is a "reset.input.minmax" command to use with upscmd. Also, > you can trigger a battery test with "test.battery.start". I assume the > work the same way as on Protocol 3003 :-) > > The attached patch is meant to be applied on top of the previous > patch. If it's easier, I can diff it against Git master.
Hello Charles, Thanks for the patch! It went down cleanly. I then did: make clean, make, and make install. Everything went fine. But I'm not able to access those additional commands ... pi@raspberrypi ~/nut $ /usr/local/ups/bin/upscmd -u pi -p pi SMART500RT1U@localhost reset.input.minmax Unexpected response from upsd: ERR CMD-NOT-SUPPORTED pi@raspberrypi ~/nut $ /usr/local/ups/bin/upscmd -u pi -p pi SMART500RT1U@localhost test.battery.start Unexpected response from upsd: ERR CMD-NOT-SUPPORTED pi@raspberrypi ~/nut $ /usr/local/ups/bin/upscmd -u pi -p pi -l SMART500RT1U@localhost Instant commands supported on UPS [SMART500RT1U]: load.off - Turn off the load immediately load.on - Turn on the load immediately shutdown.return - Turn off the load and return when power is back pi@raspberrypi ~/nut $ I will give USB sniffing a shot when I am back in the office tomorrow. Thanks! Steve Ballantyne Network Engineer MCSE/MCDST; Novell CLA; LPIC-1; CTT+; A+; Network+; Linux+; Server+; I-Net+; Security+; SonicWALL CSSA _______________________________________________ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
