Any comments please? Not reading input/output voltages is fine with me but it would be useful to read out the output load. Also I want to be sure that other critical parameters like runtime are being read correctly.
Could anyone using Smart-UPS C1500 with USB cable please share their experience? Thanks. On Sat, Nov 8, 2014 at 6:12 PM, Selva Nair <selva.n...@gmail.com> wrote: > Hi, > > I have setup NUT in netserver mode on debian wheezy with two APC UPS units > connected to it by usb. lsusb identifies the units as Smart-UPS 1000 and > Smart-UPS C1500. It appears these do not use the smart protocol and > usbhid-ups is the correct driver to use. > > System: Debian wheezy with stock version of nut > (Version: 2.6.4-2.3+deb7u1) > > Everything works rather well, except that the cgi-interface does not > report input/output voltages and load for the C 1500 unit. > upsc also reports these values only for model 1000, not for 1500. Battery > charge is and runtime are reported. > > Is this a limitation of the driver, or is there way to get these data? > > Thanks > > Selva >
_______________________________________________ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser