On May 12, 2014, at 8:46 AM, Johan Kragsterman <johan.kragster...@capvert.se> wrote:
> panic message: pcieb-0: PCI(-X) Express Fatal Error. (0x145) That's these flags from pcie_impl.h (viewable from the source, it's not an installed system header file): #define PF_ERR_NO_ERROR (1 << 0) /* No error seen */ #define PF_ERR_NO_PANIC (1 << 2) /* Error should not panic sys */ #define PF_ERR_PANIC (1 << 6) /* Error should panic system */ #define PF_ERR_MATCH_DOM (1 << 9) /* Error Handled By IO domain */ That's a lot of flags set, and all of this flag-setting happens during a fault scan of the PCIe bus (see pcie_fault.c, especially starting with pf_scan_fabric() and its descendants). I'd be inclined to say this is a HW error, especially given your e1000g3 device complained, per here: NOTICE: e1000g3 link down NOTICE: vnic1000 link down NOTICE: e1000g3 link up, 100 Mbps, full duplex NOTICE: vnic1000 link up, 100 Mbps, unknown duplex NOTICE: SUNW-MSG-ID: SUNOS-8000-0G, TYPE: Error, VER: 1, SEVERITY: Major Dan _______________________________________________ OmniOS-discuss mailing list OmniOS-discuss@lists.omniti.com http://lists.omniti.com/mailman/listinfo/omnios-discuss