James, Make sure the repeater is programmed to the proper TX/RX/ pl/DPL etc. frequencies before attempting alignment as noted in previous post. Good Luck,
Alan Rabin WA2AR Enlight Communications Inc. www.enlightcomm.com ----- Original Message ----- From: [EMAIL PROTECTED] To: Repeater-Builder@yahoogroups.com Sent: 7/13/2008 5:49:53 PM Subject: RE: [Repeater-Builder] VXR-7000 The software CE29 has a help feature press F1 to access it. The TX alignment must be done in base mode. In other words make sure the base/repeater light is off on the front panel when doing this and use a wattmeter and proper dummy load. good luck. Alan Rabin WA2AR Enlight Comm. Inc. ----- Original Message ----- From: james_thurlow2003 To: Repeater-Builder@yahoogroups.com Sent: 7/13/2008 5:03:18 PM Subject: [Repeater-Builder] VXR-7000 Help - someone tell me I'm not going bonkers. OK to put this post in context I fumble around PMR radio for events I run, have all the licenses from OFCOM and in my time programmed radios (HF and VHF) for humanitarian aid programs around the world. I've purchased a VXR-7000 repeater (used, but in as new condition by appearence). Programmed it up and it works. However its only pumping out 10/12 watts and seeing as my license allows up to 25 I'm keen to maximise coverage. Following the instructions about installtion of a duplexer I get the to bit where you hold the accessory button for 2 secs and push the PTT (Po shows) but the up / down buttons don't do nothing in adjusting the power out. Has anyone any ideas. Look forard to your replies. No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.138 / Virus Database: 270.4.10/1549 - Release Date: 7/12/2008 4:31 PM No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.138 / Virus Database: 270.4.10/1549 - Release Date: 7/12/2008 4:31 PM
