Hi n p,
I'm forwarding this report to the debian-alpha mailing list, where it's
likely to get more attention from folks who might be familiar with the
particularities of this hardware.
Thanks,
--
Steve Langasek Give me a lever long enough and a Free OS
Debian Developer to set it on, and I can move the world.
[EMAIL PROTECTED] http://www.debian.org/
On Thu, Oct 11, 2007 at 08:36:59PM -0400, n p wrote:
Package: debian-40r1-alpha-CD-1.iso and
debian-40r1-alpha-kde-CD-1.isoinstallation-reports (tried both iso)
Boot method: CD-rom via SRM console (V5.7-83)
Image version: http://cdimage.debian.org/debian-cd/4.0_r1/a;pha/iso-cd/
Date: 2007-10-08 and 2007-10-10 (each iso CD-rom respectively)
Machine: DEC AlphaServer 1000A 4/266 RM
Processor: (see Machine above)
Memory: 1024 Meg of System Memory (from SRM show memory command)
Partitions: 2 GBytes SCSI disk x 3; all 3 were detected during partitioning
phase but only the first drive was used by the default set-up
Output of lspci -nn and lspci -vnn: (do not understand this question)
Not sure if the following information is helpful: the console displayed
these lines after bus probe on power up
bus 2, slot 0 -- pka -- QLogic ISP10x0
bus 2, slot 1 -- pkb -- NCP 53C810
bus 0, slot 12 -- ewa -- DECchip 21041-AA
bus 0, slot 13 -- tga -- DECchip ZLXp 21030
Base System Installation Checklist:
Initial boot: OK
Detect network card: OK
Configure network: OK
Detect CD: OK
Load installer modules: OK
Detect hard drives: OK
Partition hard drivers: OK - only one out of three was partitioned by the
installer using guided partitioning
Install base system: OK
Clock/timezone setup: OK
User/password setup: OK
Install tasks: OK
Install boot loader: OK
Overall install: not sure - see below
Comments/Problems:
Booting and installing from the CD seemed to be all right until instructed
to reboot the server. Only default values from the installer were used (I
am very new to Linux installation)
Upon reboot, the server booted into the aboot after typing boot from the SRM
prompt.
Got Welcome to aboot 0.9b . and the aboot prompt.
Typed in 0 and the following was shown:
aboot: loading uncompressed vmlinuz...
aboot: loading compressed vmlinuz...
aboot: zero-filling 869018 bytes at 0xfc0001715ec6
aboot: loading initrd (6384427 bytes/6234 blocks) at 0xfc003f8a6000
aboot: starting kernet vmlinuz with arguments ro root=/dev/sda3
After this point the keyboard LEDs (Num Lock, Caps Lock and Scroll Lock)
would flash a few times, then the screen/console became frozen. No further
activities.
Tried left-Alt F4, left-Alt F2, nothing happened.
The machine was working before only the os was too old (Digital UNIX 3.2g).
Tried both the Debian first iso CD-rom and the KDE iso CD-rom, both had the
same problem.
Would someone be kind enough to help please? Thank you very much in
advance.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of unsubscribe. Trouble? Contact [EMAIL PROTECTED]
