John Moe пишет:
igwasm wrote:
- Original Message - From: John Moe john...@optushome.com.au
To: gentoo-user@lists.gentoo.org
Sent: Thursday, October 15, 2009 1:40 PM
Subject: Re: [gentoo-user] Installation gentoo problem.
Igor Spiridonov wrote:
Hi. I tryed install gentoo 10.0 and there was: scanning for
ata_piix and istallation stopped. If i switch off the sata disk then
installation runs good.
I try gentoo 10.1 now and stopped on: Scanning for ehci-hcd...usb
core. I switch off usb on motherboard and installation continue. But
then stopped on: Scanning for scsi_wait_scan. I have not scisi
disks. My matherboard is Asus P4P800SE. What to do?
If there's a module you don't need to load to install Gentoo, you can
use the noload option as described in the handbook
(http://www.gentoo.org/doc/en/handbook/handbook-x86.xml?part=1chap=2)
under Booting the Installation CD, as well as the options listing on
the boot screen of the install CD. Just list the modules that are
causing problems.
John Moe
Hm. noscsi? I don`t found this option.
No, not noscsi; noload. From the handbook:
noload=X
This causes the initial ramdisk to skip the loading of a specific
module that may be causing a problem. Syntax matches that of doload.
The module names to put in for X are listed in the boot sequence:
ata_piix, ehci-hcd, scsi_wait_scan, etc. Read the whole section
Booting the Installation CD in the handbook.
John Moe
__ NOD32 4496 (20091010) Information __
This message was checked by NOD32 antivirus system.
http://www.eset.com
Thank you. I try: gentoo nousb noload=scsi_wait_scan. And instalation
continue. But further:
Looking for the cdrom
Media not found
Could not find cd to boot
Could not find the root block device in
Please specify another value or Press Enter..
And froze.
