On Wed, 2013-03-20 at 20:57 +0100, Volker Armin Hemmann wrote:
> you might just hit a thrashing situation. Linux is very bad when it
> comes to abusing swap in case of an emergency.
>
> But it also sounds like overheating or a power problem. Power problems
> might be caused by the PSU - but it could also be the power circuitry
> of
> your mobo.
First of all, thank you to everyone for the superb help and suggestions
regarding this problem.
Yesterday, I enabled some swap space, but the system froze on the first
attempt at compiling glibc.
The next cheapest option was to clean the case of dust. The CPU heat
sink was clogged with a think layer of dust. After thoroughly cleaning
the case, the system compiled glibc, the kernel, qtcore and other
packages without freezing.
The only downside is since the fins on the heat sink are exposed
directly to the fan again, the noise level has gone up.
When I checked the RPMs in the BIOS I noticed a setting which states,
decrease CPU voltage and frequency in the event of a temperature
threshold being exceeded. This would explain the kernel watchdog
messages reporting stalls were detected.
For anyone that's curious, here's the output of sensors and free during
the compile of glibc. Swap wasn't being touched at all, there's still
4GB of memory free. The cpu was getting close to the threshold limit
even after the heat sink was cleaned of dust.
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +58.9°C (high = +70.0°C)
(crit = +71.0°C, hyst = +66.0°C)
it8720-isa-0228
Adapter: ISA adapter
in0: +1.49 V (min = +0.00 V, max = +4.08 V)
in1: +1.47 V (min = +0.00 V, max = +4.08 V)
in2: +3.38 V (min = +0.00 V, max = +4.08 V)
+5V: +2.96 V (min = +0.00 V, max = +4.08 V)
in4: +3.07 V (min = +0.00 V, max = +4.08 V)
in5: +3.25 V (min = +0.00 V, max = +4.08 V)
in6: +4.08 V (min = +0.00 V, max = +4.08 V) ALARM
5VSB: +2.98 V (min = +0.00 V, max = +4.08 V)
Vbat: +3.28 V
fan1: 6750 RPM (min = 0 RPM)
fan2: 0 RPM (min = 0 RPM)
fan3: 0 RPM (min = 0 RPM)
fan4: 0 RPM (min = 0 RPM)
temp1: +31.0°C (low = +127.0°C, high = +127.0°C) sensor =
thermistor
temp2: +67.0°C (low = +127.0°C, high = +127.0°C) sensor =
thermal diode
temp3: +70.0°C (low = +127.0°C, high = +127.0°C) sensor =
thermal diode
cpu0_vid: +0.525 V
intrusion0: ALARM
total used free shared buffers
cached
Mem: 8167400 3195300 4972100 0 62024
1379256
-/+ buffers/cache: 1754020 6413380
Swap: 511996 0 511996
Once again, a big thanks for everyone's help.
Regards,
Carlos
