Hi Jacopo,
Thanks for your patch.
On 2018-05-21 19:27:41 +0200, Jacopo Mondi wrote:
> Document 'data-active' property in R-Car VIN device tree bindings.
>
> Signed-off-by: Jacopo Mondi
>
> v1 -> v2:
> - HSYNC is used in place of data enable signal only when running with
> explicit synchronizations.
> - The property is no more mandatory when running with embedded
> synchronizations, and default is selected.
> ---
> Documentation/devicetree/bindings/media/rcar_vin.txt | 6 ++
> 1 file changed, 6 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt
> b/Documentation/devicetree/bindings/media/rcar_vin.txt
> index dab3118..2c144b4 100644
> --- a/Documentation/devicetree/bindings/media/rcar_vin.txt
> +++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
> @@ -64,6 +64,12 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
> If both HSYNC and VSYNC polarities are not specified, embedded
> synchronization is selected.
>
> +- data-active: data enable signal line polarity (CLKENB pin).
> + 0/1 for LOW/HIGH respectively. If not specified and running with
> + embedded synchronization, the default is active high. If not
> + specified and running with explicit synchronization, HSYNC is used
> + as data enable signal.
This indentation looks funny :-)
If you check the rest of the rcar_vin.txt file only spaces are used for
indentation.
> +
> - port 1 - sub-nodes describing one or more endpoints connected to
>the VIN from local SoC CSI-2 receivers. The endpoint numbers must
>use the following schema.
> --
> 2.7.4
>
--
Regards,
Niklas Söderlund