Hi Dan,
Thank you for your answer. I am using asterisk 1.4.13 and keepalive has a
value of 120 in skinny.conf.
2007/11/8, Dan Austin [EMAIL PROTECTED]:
Paul wrote:
I have six cisco 7911g connected on asterisk over
chan_skinny. Four of them are working OK. two of
them even the screen on
I managed to use Cisco IP phones 7911g with asterisk with Sccp and
chan_skinny without any configuration files in tftp. Only settings in
dhcpd to indicate the tftp address and skinny.conf settings. the problem
that I have is that from 8 phones two of them after working a while now are
Hi everybody,
I have six cisco 7911g connected on asterisk over chan_skinny. Four of them
are working OK. two of them even the screen on the phone is indicating that
is registered and has number loose connection to asterisk . On asterisk the
message is Skinny Client was lost, unregistering.
Hi everybody,
I have some 7911G to be used on an asterisk . Right now they are using sccp
protocol. I am trying to load a SIP firmware but until now the dealer failed
to do so.
Is there some howto files to use them on asterisk skinny channel ? I
understand that all configurations will be done
I have an asterisk pbx conected to internet. I need to connect to
asterisk a sip phone over the net that will be connected to the
internet over a NAT router. I found on the net that SIP is not very NAT
friendly. If somebody has a how-to for my problem please share it
with me . Also any experience
Hi everybody,
I am very new in asterisk community. I just compiled installed
asterisk on a fedora core 3 machine and I want for test purpose to do
a small PBX that use X-lite windows sip clients and no trunk for the
begining.
Where can I find a good how-to to do this job. A small starting