2010/11/4 Henry Ptasinski hen...@broadcom.com:
On 11/04/2010 07:39 AM, Gábor Stefanik wrote:
On Thu, Nov 4, 2010 at 1:21 PM, Ariel Pedrazapedra...@yahoo.com wrote:
I have the 14e4:4727 and using the brcm80211, this is an example of what
I get and the status of each commands:
airmon-ng #ok
airmon-ng stop wlan0 #ok
ifconfig wlan0 #ok
macchanger --mac yy:yy:yy:yy:yy:yy wlan0 #ok
airmon-ng start wlan0 #ok
airodump-ng mon0 #ok
airodump-ng -c canal -w nomarch --bssid xx:xx:xx:xx:xx:xx mon0 #ok, no
datas
In other terminal:
aireplay-ng -1 0 -a xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok,
autentication succesful
aireplay-ng -3 -b xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok, supose
to increment datas but NOP!!!
In other terminal:
aircrack-ng -b xx:xx:xx:xx:xx:xx nomarch.cap #ok, no datas...
So... when do you think that the brcm80211 implemetation will be ready to
capture datas?
Hmm... filter configuration issue? Apparently the pass other-BSS
data filter flag is not getting written to the hardware. (Do we even
have such a flag in the brcm80211 FW?)
Can you see any data packets in Wireshark on the monitor interface?
The following flags should all work with the brcm80211 FW:
MCTL_KEEPBADFCS
MCTL_KEEPCONTROL
MCTL_PROMISC
MCTL_BCNS_PROMISC
The only one that's hooked up in the driver at the moment is
MCTL_BCNS_PROMISC (for FIF_BCN_PRBRESP_PROMISC). I haven't taken a look at
what it would take to enable monitor mode in the driver yet (setting up the
monitor interface, etc).
For raw monitor mode, all but KEEPBADFCS are needed. If the fcsfail
monitor mode flag is also set, KEEPBADFCS should be enabled too.
For cooked monitor, AFAIK only KEEPCONTROL (and perhaps BCNS_PROMISC)
are needed.
However, do not set these based on interface type - use the FIF_ flags instead.
- Henry
--
Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-)
___
b43-dev mailing list
b43-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/b43-dev
