Em 17-06-2014 19:54, Nick Niemeyer escreveu:
# modinfo ixgbe
filename:
/lib/modules/2.6.32-431.el6.x86_64/kernel/drivers/net/ixgbe/ixgbe.ko
version:3.15.1-k
license:GPL
description:Intel(R) 10 Gigabit PCI Express Network Driver
author: Intel Corporation, linux.n...@intel.com
srcversion: B390E9D9904338B52C2E361
I have updated this to 3.18.7-1 as well, same results
# ifconfig bond1 |grep error
RX packets:4476995 errors:6940 dropped:0 overruns:0 frame:6940
TX packets:2130564 errors:0 dropped:0 overruns:0 carrier:0
Frame errors are usually cable error and/or alike but can also be a
result of mis-communication between driver/NIC firmware. What does
'ethtool -S' for each slave interface give you?
Marcelo
# cat /proc/net/bonding/bond1
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
Bonding Mode: adaptive load balancing
Primary Slave: None
Currently Active Slave: p6p1
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: p6p1
MII Status: up
Speed: 1 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:e2:ba:1e:12:5c
Slave queue ID: 0
Slave Interface: p6p2
MII Status: up
Speed: 1 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:e2:ba:1e:12:5d
Slave queue ID: 0
Any suggestions and help are much appreciated!
Thanks!
Nick
___
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
___
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
