[Dx4win] Serial ports

Hello, I've just installed a dual serial port card into my PC however despite all my efforts to remove the previously installed virtual USB ports the software insisted on creating them as Com 9 and 10. Windows insists com 2 - 8 are in use (only com 1 and 8 actually are) so reasigning the ports

RE: [Dx4win] Serial ports

Hello, All sorted now thanks for all the replies received direct... David -Original Message- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of David Warr Sent: 07 October 2008 11:37 To: Dx4win-Admin Subject: [Dx4win] Serial ports Hello, I've just installed a dual serial

[Dx4win] Omni VII

Hello, Does anyone know the settings to get the Omni VII talking to Dx4Win. I've tried setting the baud rate to 57600 and the address to 00 but nothing. I have output from the Omni as I can see it on my microham interface Any ideas David ___ Dx4win

RE: [Dx4win] Ft1000D

@mailman.qth.net Subject: Re: [Dx4win] Ft1000D David, I have the same settings. Also, DTR and RTS both high. Polling 5000 ms. Works fine under 7.03.16. Used to work fine under earlier versions as far as I remember. I am going through a MicroHam MicroKeyer but that shouldn't make a difference. Les W2LK David

[Dx4win] Ft1000D

Hello, I'm trying to get the CAT interface working with a FT1000D. It works fine under Writelog so I know the interface, comm port and radio is working but when I try to get it to work under Dx4Win the interface times out. I can see the rig being polled but that's all. I've selected Ft1000, 4800

[Dx4win] Dx spots

Hello, Each time a new spot comes in from the cluster the logbook window changes band/mode to match the incoming spot. I knew how to turn this off once but I just can't figure out how to do it at the moment. Regards David ___ Dx4win mailing list