Hi,
As I slowly expand my knowledge in homebrewing, I've decided an XG3 should
be my next piece of test equipment (after a DMM and a Rigol DS1102E 'scope).
My main interest in the XG3 is for receiver alignment and RF tracing.
I'd like to know people's opinions and experiences with this
I just want to confirm something. The instructions refer to board revision C.
Myboard is Rev. Cr. That's not same as C, right?
Thanks.
73,
Bob KD2UJ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
Just an FYI since it's a little hard to find, the RFPROBE kit is on this
page http://www.elecraft.com/order_form_parts.htm#K2%20Parts under K2 PARTS
AND MOD KITS.
Bob KD2UJ
__
Elecraft mailing list
Home:
Hi,
With superior dexterity, perseverance, dumb luck, and a lot of help from Don
W3FPR my K1 is complete and working on 40 and 20 meters. This is my first
kit rig, my first QRP rig, and my first CW only rig.
When I set out to buy a QRP rig, I looked at everything I could find on the
Web.
Don,
First of all I couldn't have solved this without your help. Thanks very
much. Elecraft should be paying you for your services.
The symptom was no power out during the band alignment of a 2-band filter
board in 9. Alignment and Test, Part II. Here is a recap of what it took
to fix this
Hi,
I'm in Chapter 9, Alignment and Test, Part II. I've done the first set of
voltage checks and the values are all good.
Now I have moved on to Band 1 Alignment (40 meters). No position of L1, L2,
L5 or L6 has any effect. The display continues to show P0.1. (Also tried
Band 2 (20 meters)
Hi,
I'm up to page 29 in the manual and doing the first resistance checks on the
RF board. I have problems with these 4 test points:
P1 pin 16
P1 pin 17
U4 pin 6
U4 pin 7
My DMM sometimes shows resistance on these points, then it climbs until it
indicates an open. Sometimes it just
Hjalmar Don,
Thanks very much. Im sure thats the right answer. It must be, its the one
I was hoping for.
73,
Bob
KD2UJ
From: Hjalmar Duklæt [mailto:dukl...@broadpark.no]
Sent: Thursday, July 26, 2012 16:07
To: Bob Molloy; elecraft@mailman.qth.net
Subject: Re: [Elecraft] [K1
Can't figure out how to store the long arms when they're not in use with the
hardware provided and would appreciate some help.
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
9 matches
Mail list logo