[Elecraft] K2 #4785

Hi all. K2 #4785 is well under way no major problems yet. my kit was supplied with inductor L31 10uh. but due to xtal not being 'rubber' enough ref Gary at support, to give me the correct pll range. I am waiting on a replacement for L31 with a value of 12uh The manual states a prefered range of

[Elecraft] K2 #4785

Hi all I have just finished alignment and test part 1 all is good except the test for setting the AGC threshold when I adjust R1 i can only get a max voltage of 3.30v is this ok ?. Thanks Mick M1MGD.. ___ Elecraft mailing list Post to:

[Elecraft] K2 4785

Thanks Jim. I will try that Mick M1MGD.. ___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft

RE: [Elecraft] K2 #4785

Mick, I might believe 3.75 volts or above may be OK, but if you have run out of adjustment range at 3.3 volts, something is wrong. First, check the voltage out of your 8 volt regulator (Control Board U4). If it is OK, look at the schematic for the Control Board (lower left corner) to identify

[Elecraft] K2 #4785

Hello all K2 #4785 Has arrived in the UK today no parts missing..5 days to get here wow. 2 years since i built my K1 #1532 so this should be fun. Mick m1mgd ___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber