Hi,
I’m still trying to pin down the cause of
the low-ish volume of my K2 (s/n 6905), which seems to be something
occasionally reported with
this transceiver.
Dave White, VE6DRW, recently sent me the
documentation of the AGC mod to try. (Thanks Dave for digging it out for me – I
On Thu, Aug 18, 2011 at 11:38 AM, Ian Liston-Smith ian...@hotmail.co.ukwrote:
I’m still trying to pin down the cause of
the low-ish volume of my K2 (s/n 6905), which seems to be something
occasionally reported with
this transceiver.
There are some number of things you do not mention.
1)
Hi Ian,
Do you have access to a RF signal generator, or can you build the crystal
oscillator source shown in the troubleshooting section of the K2 manual?
I've found the receiver signal tracing protocol described there to be
helpful. The RF probe supplied with the K2 is useful if you have a
I am very hard of hearing. Is there a way to increase the volume in this
radio. My K1 is much louder.
George/W2BPI
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
George,
The available audio from the K2 is not as much as for the K1. The K1
has an extra audio stage.
If you have to run the AF Gain on the K2 to maximum, then I would
suggest that you use an external amplifier. Some amplified computer
speakers will do the job fine, while others pick up RF
Tom,
I would say that you have some problem with that K2 - unless you have a
very poor antenna.
I would suggest that you first try the Cheap and Dirty Signal Tracing
methods that you can download from the Builder's Resource page at the
Elecraft website.
If that does not produce an answer
((I have K2 06660 with KAT-100, KDSP2, KNB2-R, KPA100-R, KSB2-R, KUSB
installed.))
((Currently in process of replacing KSB2's U3 for SSB problem. Can not
transmit SSB. (Posted on this site last week and got 3 direct responses within
several hours! New part fm. Elecraft in 2 days!)))
Kit is
I pick up stations on my K2 without an antenna hooked up.
I also get way more then enough volume.
I never need or use the preamp below 20 meters.
Did you check the antenna with a different receiver?
I am not fond of coincidences, no ssb output, weak receiver
Sounds like it might be time for
kc4eyf Here!
To veteran k2'ers
Building #4877 k2
I have completed
Alignment and Test,Part 1
Alignment and Test,Part 2
I Have Two Questions
1-Should I be picking up 40 meter
band signals at this point CW/
2-Will my volume increase as I
Proceed with project
Might be a dumb question
but im
N7AF
- Original Message -
From: randt [EMAIL PROTECTED]
To: Elecraft@mailman.qth.net
Sent: Thursday, April 14, 2005 12:41 PM
Subject: [Elecraft] K2 volume
kc4eyf Here!
To veteran k2'ers
Building #4877 k2
I have completed
Alignment and Test,Part 1
Alignment and Test,Part 2
I Have Two
Not a dumb question at all. At this point you should have all the receiver
you ever will get on 40 meters, and you should be hearing 40 meter signals
loud and clear with the AF gain set at about the 9 o'clock position. If
that is not true, either the band is dead, you have a poor antenna, or
11 matches
Mail list logo