Hi-
On Tuesday, May 27, 2008 8:58 PM, I sent this message to the reflector and
haven't seen any comments... maybe I am too anxious, but I am also anxious to
cure this problem- so again, I say:
Hi-
OK, the K3 works fine using computer generated PSK 31 AFSK, but when I go to
the internally
Dave,
Are you in Data-A mode when using audio based PSK31? If so, adjust your
filter FC
to 1.0. The BW can be what you want it to be, I normally start mine off at 1.0
kHz.
If you transmit your signal right at 1.0 kHz on the waterfall in Data-A it
should
be the same as when using PSK-D.
Hmm, I responded with this message:
http://www.nabble.com/Re%3A-K3%3A-Using-built-in-PSK--p17503377.html
Since you remarked that when you monitored your transmitted signal it
didn't have fullness I thought that you might be sending only an
idle signal, which would be the case if you were trying
Bob Cunnings wrote:
Hmm, I responded with this message:
http://www.nabble.com/Re%3A-K3%3A-Using-built-in-PSK--p17503377.html
Since you remarked that when you monitored your transmitted signal it
didn't have fullness I thought that you might be sending only an
idle signal, which would
Hi-
OK, the K3 works fine using computer generated PSK 31 AFSK, but when I go to
the internally generated PSK 31 D, 31 bps, I do not get responses to my calling
CQ or calling stations. The TX and RX filter width is set to 2.7 KHz. I can
copy perfectly on the radios VFO B copy line and do get a
It only works using the paddle input, not the straight key input - can
this be your problem?
Bob NW8L
On Tue, May 27, 2008 at 6:58 PM, Dave [EMAIL PROTECTED] wrote:
Hi-
OK, the K3 works fine using computer generated PSK 31 AFSK, but when I go to
the internally generated PSK 31 D, 31 bps, I
6 matches
Mail list logo