KEVIN: If you see this, my S/N is 642, not 624. Not only did I QLF it
on the air in ECN, I remembered it all wrong as well. I think it's
called "age." :-(
ALL: Assembly went really great, no problems; follow the directions.
Lots of screws, multiple kinds of washers, and a few nuts [what would
ham radio be without a few nuts]; a muffin tin or two and a ruler helps
a lot. Two momentary panics: One after the KPA3 was done and I
couldn't get the power above about 12W. As a last resort :-) I read the
manual and found out the CONFIG:PAio menu, which was turned ON, only
applies if you have the IO module installed but not the amp itself.
Proceeding up the choices, I then found CONFIG:PA, turned it to 'nor',
and 100W wafted from my beam.
Other panic: I have a little Radio Shack audio amp I use to get my
radios up to afterburner roar since my hearing aids don't work under the
headphones. I tried it, and the AF Gain was about 9 o'clock for good
listening. Later hooked it up again, and virtually no sound from the
radio, even with the AF Gain maxed out. No antenna -- end of panic.
This is a veeeerrrry quiet radio!
At the tool store in town, I picked up 3 or 4 little stainless surgical
clamps awhile ago. They are very useful for getting screws started
without dropping them into the guts of the radio. I had to use a
fingernail file to round off the mini-coax plugs from the Ref Osc, but
that was easy. No other issues. This is a clean kit for sure.
I've had a couple of weeks with it now and I can't really come up with
my top ten "likes," there are so many. But I know a big one is that the
radio comes alive right after calibration in a highly usable state
without much menu tweaking. Just enable the modules you have, and
you're on the air, mess around with the menu entries at your leisure.
Nice job Elecraft! I'm a happy ham. We'll try it out in WPX CW this
weekend after #3 grandson Joe gets married Sat. Most everyone will have
the K6 mult by the time I get on.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 2008 Cal QSO Party 4-5 Oct 08
- www.cqp.org
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com