Re: [Elecraft] K3 AR0 & AR1 commands not working

2018-04-27 Thread Rich - K1HTV
Hi Wayne, Upgrading to the latest 5.64 version of K3 firmware corrected the problem. I can now change the 'RX ANT' by using the AR1 & AR0 commands. When I ran the K3 Utility earlier, and checked for the latest K3 release firmware release, it indicated that 5.57 was the most current version

Re: [Elecraft] K3 AR0 & AR1 commands not working

2018-04-26 Thread Wayne Burdick
I’m assuming you do have a KXV3 installed? Make sure you’re not in BSET or VFO A/B REVerse when you send the command. Also try sending just “AR;” in the command tester and see if you get a response. If you don’t, then you must have older firmware without the command implemented. 73, Wayne

[Elecraft] K3 AR0 & AR1 commands not working

2018-04-26 Thread Rich - K1HTV
I have been unsuccessful in being able to control the K3 "RX ANT" using macros with either the AR1 (on) or AR0 (off) commands. Manually tapping the 'RX ANT' button on the K3 will correctly toggle the K3 receiver between the MAIN and RX ANT (Beverage) antennas. Using the latest version of the