Hi,
Haven't been on the air much, the K3 has been unplugged antennae
disconnected just to protect against lightning possibilities. Last I
used the rig, I was mostly on the lower bands, rarely 15 meters or
above.
just for fun I went to check my butternut HF9V to see if there were
any issues
On Thu, Jun 10, 2010 at 1:02 AM, Gary Smith g...@ka1j.com wrote:
Hi,
Haven't been on the air much, the K3 has been unplugged antennae
disconnected just to protect against lightning possibilities. Last I
used the rig, I was mostly on the lower bands, rarely 15 meters or
above.
just for fun
When was your K3 shipped? If it was shipped before Dec 22, 2008 you may
need to apply this modification to your radio:
http://www.elecraft.com/K3/mods/ELECRAFT_Application_Note_KSYN3_ALC_Rev_A.pdf
~Brett (N7MG)
On Wed, 2010-06-09 at 21:02 -0400, Gary Smith wrote:
Hi,
Haven't been on the air
Iain Brett,
Thanks for the speedy replies. I will check it out. I did get my K3
right around Dec 20 08 (my birthday). What is interesting is this has
never come up before and I have used the K3 utility to calibrate
several times. I did make a few 24MHz contacts in March so it was
working
If you're careful you can get the synthesizer boards out of the radio
without removing the subRX. I just got done installing the stiffeners
onto my synthesizers and didn't have to remove the subRX to do so but
you do need to remove the 2 Meter internal transverter if you have that.
Also when you
For the moment, the problem has fixed itself..Hmmm
Any ideas
Gary
Sent via BlackBerry® from Telstra
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post:
Hi yet again,
Tried transmitting but the fault returned, no Tx/Rx, complete failure now.
Gary
Sent via BlackBerry® from Telstra
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
I just started noticing that I get a quick message of ERR PL 1 when I
change bands. When I hit the band switch to go up or down it says ERR
PL 1 then shows the frequency.
I recently went to Version 2.23, but went back to 2.22 and have the same
message popping up.
Is this normal?
Rich -
Well a reload of 2.23 appears to have solved the problem.
Rich - N5ZC
Richard Thorne wrote:
I just started noticing that I get a quick message of ERR PL 1 when I
change bands. When I hit the band switch to go up or down it says
ERR PL 1 then shows the frequency.
I recently went to Version
I just started noticing that I get a quick message of ERR PL 1 when I
change bands...
Is this normal?
No. Try re-running VCO Cal. If that doesn't fix it, please contact
k3support.
73,
Lyle KK7P
___
Elecraft mailing list
Post to:
I was setting up some band edge memories (KM5Q's post of 5/10). I goofed and
hit MV instead of VM. Then selected an 'empty' memory position, the main freq
display was - - - -. I hit MV again. The VFO jumps to 49.9940 mHz and
displays ERR PL 1
Seems like the MV routine should test for a
11 matches
Mail list logo