When I install the KXPA100 (with ATU) with the KX3 & PX3 I am unable under the “PA MODE” menu item to select “ON”. I only have two choices in this menu, “OFF” and “Pout CAL”. When I turn the VFO A to the left from the “OFF” setting, there are two relay clicks only. When I remove the plug from the “ACC 1 PC” plug on the PX3, and move it to the KX3 (after removing the one there that runs to the “ACC1 RCVR” I have the same behavior, however if I restart the PK3, it will now activate the KXPA100 and operate normally.
I have triple checked the wiring. PX3 operates as expected (although the rotary encoder is a bit jumpy, but that’s another story.) Firmware Versions: KXPA100: 1.32 PX3:1.39 KX3 MCU 2.38, DSP 1.37 Any advice on what is going one would help! Thanks! 73 KK4LGZ Josh ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
