Should have mentioned that I was unable to set Sub NR after loading beta
3.76 complete with new DSP FW.
Sub works great otherwise.
jim ab3cv
On Mon, Jan 25, 2010 at 11:07 PM, Jim Miller j...@jtmiller.com wrote:
I've activated Bset but when I hold the NR button I don't get a Fx-x
indication
Jim,
In that case it should work. Is there any chance you are in either DATA
or FM mode? Noise Reduction is N/A for those modes.
I don't have the sub here to try it, so perhaps someone who has the sub
can try it on their K3 with 3.76 beta firmware.
73,
Don W3FPR
Jim Miller wrote:
Should
It works. You have to be sure you have the Sub Rx turned ON when you
attempt to turn NR on or off using b-set
73,
Ken K3IU
K3 #202
On 1/26/2010 8:58 AM, Don Wilhelm wrote:
Jim,
In that case it should work. Is there any chance you are in either DATA
or FM mode?
on my K3 with FW 3.76 loaded I can set NR settings with BSET for the
subreceiver, but it is then changed also for the main receiver. I can use
NR on the main or sub or for both, but with the same NR settings for the
same mode.
73! de Werner OE9FWV
Don Wilhelm schrieb am 26 Jan 2010 um 8:58:
With Sub Rx ON, I can toggle NR ON/OFF in Sub Rx using bset. This does
not affect the ON/OFF status of the Main Rx. However, when I change the
NR setting (press/hold NR) of the SubRx, that changes both the SubRx and
Main Rx setting... just as Werner reports below.
73,
Ken K3IU
NR settings are per-mode, but they'll be the same for a given mode on
each receiver. I.e., you can't (at present) have different NR settings
for CW on main vs. CW on sub.
NR on/off is per-band/per-receiver.
This will be clarified in the next K3 manual (and before that, in the
errata).
73,
Operator error: didn't have the Sub turned on when doing the Bset.
Working now.
tnx
jim ab3cv
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post:
I've activated Bset but when I hold the NR button I don't get a Fx-x
indication for setting the Sub NR.
Didn't see anything in the manual or scanning throught the Config settings.
How is this done?
tnx
jim ab3cv (sub newbie)
__
Jim,
Contrary to what the manual says, the state of NR is the same for both
the Main RX and the SUB.
Wayne has indicated that the manual is not correct in this particular
aspect and will be corrected in the next manual revision.
73,
Don W3FPR.
Jim Miller wrote:
I've activated Bset but when I
To: Jim Miller
Cc: Elecraft Reflector
Subject: Re: [Elecraft] NR adjust on sub?
Jim,
Contrary to what the manual says, the state of NR is the same
for both
the Main RX and the SUB.
Wayne has indicated that the manual is not correct in this particular
aspect and will be corrected
10 matches
Mail list logo
