Hello everyone,
I'm currently assembling a KAT1 for use with my already-completed K1-4
(which I'd previously been using with an external tuner), and I'm
having some trouble with the final step of the SWR bridge adjustment
of trimmer capacitor C9. I did verify the previous steps of setting
power
Hello everyone,
I'm currently assembling a KAT1 for use with my already-completed K1-4
(which I'd previously been using with an external tuner), and I'm
having some trouble with the final step of the SWR bridge adjustment
of trimmer capacitor C9. I did verify the previous steps of setting
power
Mark,
You did try the measurement during transmit did you not? It will be
zero volts when there is no power going through the wattmeter section of
the tuner.
Check the orientation of the diodes, and check T1 for correct
connections and good tinning of the leads - if you cannot see a bit of
Don,
The rig was in 'TUN' mode as according to the instructions, but I wasn't
actually keying down. Perhaps I missed that?
I checked out T1 but I'll triple check it this evening, and I'll also test
the diodes with my DMM since I'm certain of their orientation on the board.
Don Wilhelm wrote:
Looks like the problem was the simplest -- I just wasn't in transmit. Sheesh.
But better late than never, I suppose. Thanks again for your time, Don ...
73,
Mark / KB3OKS
KB3OKS - Mark wrote:
I checked out T1 but I'll triple check it this evening, and I'll also test
the diodes with my
5 matches
Mail list logo
