[Emc-users] (no subject)

2012-04-08 Thread Geoff Roehm
1947...@att.net -- For Developers, A Lot Can Happen In A Second. Boundary is the first to Know...and Tell You. Monitor Your Applications in Ultra-Fine Resolution. Try it FREE! http://p.sf.net/sfu/Boundary-d2dvs2

Re: [Emc-users] LinuxCNC: The new name of the Enhanced Machine Controller

2012-01-17 Thread Geoff
. There are 3 named EMC or a variation of that. There are 108 entries containing the word EMC. I;'d love to see results from Europe and Japan et al. Cheers, Geoff. -- Keep Your Developer Skills Current with LearnDevNow

Re: [Emc-users] I need advise on how to configure EMC2 PID servo to control RPM.

2011-02-04 Thread Geoff
with lightly loaded diesels is bore glazing. It usually manifests as low power under test. I have no idea how modern common rail engines behave. My (small) experience is with older military aircraft ground power units (28VDC at 1000 amps, giddy up!!). Cheers, Geoff

Re: [Emc-users] Stepper configuration

2008-08-13 Thread Geoff
for. It will take one of the gurus to tell which might handle realtime better? Right now my desk Linux box is a HP PA-RISC box, _very_ reliable and built like a brick outhouse :-). Cheers, Geoff. - This SF.Net email is sponsored

Re: [Emc-users] Step Direction Timing Page

2008-05-02 Thread Geoff
built a set and tested them rat's nest style with EMC. I am yet to integrate them with my mill. If all else fails i'll do it the hard way and post the data here. Cheers, Geoff. - This SF.net email is sponsored by the 2008