Original-Nachricht
Datum: Thu, 06 Sep 2007 00:17:41 -0500
Von: Jon Elson [EMAIL PROTECTED]
An: Enhanced Machine Controller (EMC) emc-users@lists.sourceforge.net
Betreff: Re: [Emc-users] Need advice on building a mill controller with EMC2
Gerhard Pircher wrote:
Von: Jon
Hi,
I'm seeking for some comments about how to build a mill controller with
EMC2, as I'm completely new to this topic.
I got a 12 years old desktop mill, which was manufactured by KERN-
Microtechnic [1]. The machine is in a very good condition, but some parts
of the original mill controller (a
Your setup sounds very much like my Anilam setups. Tach feedback to
drives, encoder feedback to controller, +-10V velocity command signal
from controller to drive. I used a Mesa 5i20 ($199) and 7i33 ($69), I
also use a 7i37(69) for I/O. I was originally looking at the Motenc
Lite card but
Gerhard Pircher wrote:
Hi,
I'm seeking for some comments about how to build a mill controller with
EMC2, as I'm completely new to this topic.
I got a 12 years old desktop mill, which was manufactured by KERN-
Microtechnic [1]. The machine is in a very good condition, but some parts
of the
Hi,
The Mesa card looks interesting. Do you use it with the SoftDMC Digital
Motion Control Firmware? What drivers do you use for the servo motors?
Gerhard
Original-Nachricht
Datum: Wed, 5 Sep 2007 08:42:38 -0500
Von: RogerN [EMAIL PROTECTED]
An: Enhanced Machine Controller
Original-Nachricht
Datum: Wed, 05 Sep 2007 11:47:09 -0500
Von: Jon Elson [EMAIL PROTECTED]
An: Enhanced Machine Controller (EMC) emc-users@lists.sourceforge.net
Betreff: Re: [Emc-users] Need advice on building a mill controller with EMC2
You might also take a look at my
On Wed, Sep 05, 2007 at 09:45:49PM +0200, Gerhard Pircher wrote:
The Mesa card looks interesting. Do you use it with the SoftDMC Digital
Motion Control Firmware?
With emc2, the hostmot firmware is used.
With hostmot, emc sends velocity commands and reads encoder counts,
performing closed-loop
